Install the GracoConfig Software
Download the Preconfigured Database to the Gateway Module
Graco supplies a preconfigured database as a setup file for the Gateway, containing parameters which communi- cate between the Gateway and the ProMix 2KS. The file name has a .gg2 extension.
GracoConfig files are downloaded to the Gateway mod- ule using the Link menu. The programming link between the PC and the Gateway module uses the USB cable.
Before downloading, check that the Communications Port is set to USB, as follows.
NOTE: During programming the Gateway module may ask for an updated driver. Follow the instructions on the screen to automatically find and select the drivers.
1.Go to Start>Programs>Graco>GracoConfig and run the program. The GracoConfig main page will appear.
Link Pulldown Menu | Update Symbol |
2.Using the Link pulldown menu, select Options to open the Link Options window. Check that the Com- munications Port is set to USB, and click OK.
FIG. 16: Set Communications Port to USB
3. Go to File>Open and select the file with the xx.gg2 extension. The file name should appear at the top of the window (FIG. 15) once loaded.
4. Download the database using the Link>Update
command. As a shortcut, use the Update 
symbol on the toolbar. See FIG. 15.
NOTE: Downloading typically takes only a few sec- onds but may take longer if the software has to update firmware on the Gateway module.
FIG. 15: GracoConfig Main Page
14 | 312785C |