ETHERNET
Green/Amber
LED
Yellow LED
FIG. 9: Ethernet Connection
Install the Gateway Module Hardware
Standard Ethernet Cable
TI13973a
Mount the Control on DIN Rail
The Gateway control mounts on a DIN rail. Tilt the con- trol and push down onto the DIN rail, then push in. See FIG. 10. A minimum clearance of 1 in. (25 mm) above and below the control is required to ensure adequate ventilation.
Install CompactFlash® Card
The CompactFlash socket accepts either Type I or Type
IIcards. These cards are available at most computer and office supply retailers. Use cards with a minimum of 4 Mbytes and a maximum of 2 Gbytes. Use the Com- pactFlash card for optional database storage only. See FIG. 11.
TI13965a
1 in. (25 mm) minimum clearance top and bottom
Insert card with top side on the left. Do not insert or remove card while power is applied.
TI13967a
FIG. 11: Install a CompactFlash Card
TI13966a
FIG. 10: Mount the Control on a DIN Rail
312785C | 11 |