Sterling 6017 series installation manual Servicing the Unit Monthly or Every 500 Hours

Page 48

Servicing the Unit Monthly or Every 500 Hours

•Lubricate the pump at the grease fittings with a high- quality polyurea grease rated at 320ºF or higher. Recommended: Chevron Black Pearl; do not over-lubricate.

•Adjust the pump drive belt tension. Use the belt tensioning specifications listed in this chapter on Page 51. Make sure that the motor pulley is properly aligned with the pump pulley; use a straightedge to check. Tighten motor mounting bolts after realignment.

•Inspect the screen in the Y strainer for accumulations of debris. Clean as needed.

Servicing the Unit Every Three Months

Remove and clean the screen in the Y-strainer. Replace the screen if it is damaged.

Page 48

6017 Series Hot Oil Large Temperature Control Units

Image 48

Contents Series Large Hot Oil Temperature Control Units $30.00Series Hot Oil Large Temperature Control Units Safety Considerations Table of Contents Startup Preparations Charts and Figures Introduction Necessary DocumentsStandard Features Models CoveredFeature Descriptions Available OptionsImmersion Heaters Heater Tank PumpFul-Flo Valve Cooling Connection LinesOptional Electrical System Controls Electrical Panel and System Components Air PurgePressure Switch Safety ThermostatReservoir Tank Series Hot Oil Large Temperature Control Units 50 kW 100 kW 150 kW 200 kW 90 gpm 150 gpm 200 gpm Lbs Unpacking and Inspection Event of Shipping DamagesIf the Shipment is Not Complete If the Shipment is Not CorrectReturns Installation Requirements Installation Location ConsiderationsWork Rules Connecting Piping Piping Considerations for Mobile Installations Customer is responsible for conversions to metric standardsConnecting Process Piping Connecting Cooling Water PipingConnecting Vent Piping Series Hot Oil Large Temperature Control Units Typical Flow Schematic Custom Process Piping Making Electrical Connections Series Hot Oil Large Temperature Control Units Series Hot Oil Large Temperature Control Units Startup Preparations Starting the UnitUnit START-UP with Autovent Solenoid Series Hot Oil Large Temperature Control Units Shutting Down the Unit Returning Fluid to the TankSeries Hot Oil Large Temperature Control Units Using Controls and Indicators Microprocessor ControllerStatus Indicators Display IndicatorsIdentifying M2B Controller Panel Components Screen DisplaysAlarm Indicators Using M2B Controller Keys Motor Fail IndicatorSET Point Key UP Arrow KeyIndex Key Alarm HI Alarm Key Alarm LO Alarm Key Enter KeyIdentifying Control Panel Switches Display KeyDigital Flow Screen Mode Select Pump StartPump Stop Vent Cycle Start optionalIdentifying System Status Board Indicators Alarm SilenceStatus Indicator Lights Mode Indicator LightsFault Indicator Lights Auto Mode Indicator LightPump Overload Indicator Light Low Pressure Indicator LightHigh Level Indicator Light Low Level Indicator LightSeries Hot Oil Large Temperature Control Units Periodic Checks Making Daily ChecksMaking Monthly Checks Routine Servicing Making Quarterly ChecksMaking Six-Month Checks Servicing the Unit Monthly or Every 500 Hours Servicing the Unit Every Three MonthsMotor Lubrication Procedure Corrective Maintenance Pumps and SealsSeries Hot Oil Large Temperature Control Units Troubleshooting Check the heater output with an Service Notes Service Notes Service Notes Technical Assistance Parts Department