Dswpro Remote Control, Volume Settings

DSWPRO REMOTE CONTROL	IR Receiver
DSWPRO Series subwoofers come with a
credit card sized remote control. All com-
mands are sent to the subwoofer via IR
control. The IR receiver is located on the
front of the subwoofer when the subwoofer
is in its downward firing configuration.

The remote control has the following features:

•Power

• Volume

• 4 Button Phase Control

(0, 90, 180 and 270 degree settings)

• 4 Button Polk Room Optimizer

(PRO™) presets

• Mute function

•Night function allows you to hear low-level bass detail at lower volumes. If you have the volume at 30 and press “night,“ the volume is reduced by 50%, in this example to 15. Pressing “night“ a second time restores the volume to its original setting.

Pressing Volume+ (or Volume-) incrementally increases (or decreases) the volume in the normal manner and takes the subwoofer out of “night“ mode. Also, the LED shines at a reduced intensity when the subwoofer is in “night“ mode.

•Reset button restores the woofer’s settings to factory presets. Hold down for two (2) seconds.

•LED turns LED On/Off. The amplifier remains active.

Important: To activate the remote control for the first time, remove the plastic tab.

WHAT IS THAT BLINKING BLUE LIGHT?

Behind the logo badge on the front of your subwoofer there is a blue LED. The blue light blinks whenever you press a button on the subwoofer’s remote control. The light lets you know that the subwoofer has received the command and is enabling the function you’ve selected. The following table describes each button’s function and how the LED communicates to you:

VOLUME SETTINGS

	Blue LED Indicator
Volume Level	Long Blinks	Short Blinks
40	4	0
39	3	9
38	3	8
37	3	7
36	3	6
35	3	5
34	3	4
33	3	3
32	3	2
31	3	1
30	3	0
29	2	9
28	2	8
27	2	7
26	2	6
25	2	5
24	2	4
23	2	3
22	2	2
21	2	1
20	2	0
19	1	9
18	1	8
17	1	7
16	1	6
15	1	5
14	1	4
13	1	3
12	1	2
11	1	1
10	1	0
9	0	9
8	0	8
7	0	7
6	0	6
5	0	5
4	0	4
3	0	3
2	0	2
1	0	1
0	0	0

Power	LED is on when power is active and is off when power is
	not active. (Pressing the LED button on the remote will also
	turn the LED off.)
Volume	LED will blink a 2-digit code indicating volume setting from
	0 to 40 (i.e., if the volume is turned up to 28, the LED will
	flash two long blinks followed by eight short blinks).
Mute	LED blinks slowly when “mute” is selected.
Phase	0 degrees—1 blink; 90 degrees—2 blinks;
	180 degrees—3 blinks; 270 degrees—4 blinks.
Night	LED is on at a lower intensity; volume is reduced by 50%.
PRO Presets	Cabinet—1 blink; Corner—2 blinks;
	Mid-wall—3 blinks; Mid-room—4 blinks.
Reset	LED will blink 4 times.
LED	Turns LED on/off. The amplifier remains active

10Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)