4
I n s t a l l a t i o n 
4.Ensure both side plates are at the same height
(A) by measuring to the bottom of the side plate
from a fixed location on the chair.
5.Adjust side plates to be parallel to push handles when looking down on the side plates from
behind the chair. Tighten upper and lower clamps on both sides.
NOTE– For | A |
that the upper clamp fastener (B) is in the approx- | |
imately same location of the slot for both side |
|
plates. |
|
I n s t a l l a t i o n | 5 |
| A |
NOTE– It is Important to ensure that both left and right side plates are installed at the same height and parallel to the push handles. Check that all fasteners are tight before moving on to the next step.
Figure 3
B |
Figure 6 |
Figure 4
B |
Figure 5
BACK SHELL INSTALLATION
Tools: 3/16 Allen wrench
1.Loosen the upper (A) and lower (B) connectors by loosening the two fasteners that hold each connector to the back shell.
CAUTION– Loosen both fasteners equally to allow the connec- tors to freely slide back and forth but do not remove the fasteners or loosen more than required to achieve free sliding motion.
2.Place back shell onto chair by adjusting both lower connectors to fit over pivot pins (C).
3.Adjust both upper connectors to fit into back shell receiver (D).
E |
D |
C |
Figure 7
XT200005 Rev. B | XT200005 Rev. B |