Invacare PANTHER LX-4, PANTHER MX-4, LYNX LX-3PLUS Suggested Maintenance Procedures

Page 16

SAFETY INSPECTION/ MAINTENANCE

SAFETY INSPECTION/MAINTENANCE			PROCEDURE 2

ITEM	INITIALLY		INSPECT/ADJUST
		WEEKLY MONTHLY PERIODICALLY

TIRES (PROCEDURE 9)
Inspect for flat spots and wear.	X	X
If pneumatic tires check for proper inflation.	X		X
CAUTION: As with any vehicle, the
wheels and tires should be checked
periodically for cracks and wear, and should
be replaced.

CLEANING
Clean upholstery and armrests.	X
Clean molded frame.			X

FRONT AND REAR SHOCKS -
PANTHER MX-4 ONLY
Bolts are tight.	X		X

CLEANING	X			X

HEADLIGHTS (where applicable)
Inspect headlight bulbs for proper operation.	X	X

MAINTENANCE

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise, injury or damage may occur.

CAUTION

DO NOT over-tighten hardware attaching to the frame. This could cause damage to the frame.

SUGGESTED MAINTENANCE PROCEDURES

1.Before using the powered scooter, make sure all nuts and bolts are tight. Check any parts for damage or wear and replace. Check all parts for proper adjustment.

2.Ensure that batteries are properly maintained and charged as required (PROCEDURE 4).

3.Inspect brake for proper operation (PROCEDURE 3).

4.The wheels and tires should be checked periodically for cracks and wear, and should be replaced by a qualified technician.

5.Regularly check for loose nuts and/or bolts in the front and rear wheels. If loose, have them adjusted by a qualified technician (PROCEDURE 9).

6.Clean dirt, dust and grease from exposed components.

7.Periodically have the bearings of the front wheel checked to make sure they are clean and free from moisture.

Invacare Scooters

16

Part No. 1090132 Rev F

Image 16

Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications General Guidelines Procedure General WarningsOperating Information General GuidelinesRamps Procedure General GuidelinesElectrical Weight Limitation General Warnings Grounding InstructionsBatteries Rain TestGeneral Guidelines Important Information SAFETY/HANDLING Percentage of Weight DistributionStability and Balance Always wear your seat positioning strapStairways ESCALATORS? SorryDelta Tiller Standard TillerSafety INSPECTION/MAINTENANCE Safety INSPECTION/ MaintenanceSuggested Maintenance Procedures MaintenanceSafety INSPECTION/MAINTENANCE Procedure Lubrication Points Figure Detail aTroubleshooting Guide Procedure Safety INSPECTION/MAINTENANCEControl Panel Features Operation ProcedureALL Scooter Models With Delta or Standard Tillers FigureProcedure Operation Detail a ZOOM-3Delta Tiller Panther MX-4 WWith Delta Tillers Figure Panther MX-4 Scooters onlyDetail F Procedure Operation Operation of the Scooter FiguresUsing the Hand Brake LEVER/BRAKE ARM Figure Hand Brake LeverBrake ARM Delta TillersALL Models Except Panther MX-4 Figure Brake Release LeverPanther MX-4 only Figure Fuse Replacement Reset Circuit BREAKER/FUSE Replacement FigureCircuit Breaker REMOVING/INSTALLING the Batteries with Cables Figure Procedure BATTERIES/CHARGINGRemoving BATTERIES/CHARGINGBATTERIES/CHARGING Procedure Recommended Battery TypesReplacing the Batteries Figure BATTERIES/CHARGING Cleaning Battery Terminals DiatelyModel Battery Charger Power Cord Charging the BatteriesRemote Battery Charger Figure ON-BOARD Battery Charger FigureBattery Charger Operation Figure Battery Charger Operation Remote and ON-BOARDREMOVING/INSTALLING the Seat Seat ProcedureDetermining Seat Post Type Figure SeatProcedure Seat Installing FigureRemoving Figure Adjusting the Seat Height Solid Seat Post FigureAdjustable Height Seat Post Figure Detail aAdjustment Adjusting the Seat DepthALL Models Except ZOOM-3 Figure Using the Adjustable Seat Slide Figure Adjusting the Seat DepthREMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion Figure InstallingREMOVING/INSTALLING FOLDING/UNFOLDINGBack Figure Back CUSHION/UPHOLSTERY FigureAdjusting the Back Recline Adjusting the HeadrestBack Procedure ALL Models Except ZOOM-3, SX-3 and LX-3 FigureAdjustment Armrest Angle AdjustmentArmrest Width ALL Models Except ZOOM-3 Figure Depth Armrest DEPTH/HEIGHT AdjustmentHeight Figure Tiller Angle Adjustment Tiller AdjustmentProcedure Tiller Adjustment Fold Down Tiller ZOOM-3 FigureALL Other Models Figure FivePosition Models Built AfterProcedure SHROUD/WHEELS REMOVING/INSTALLING the Rear Shroud FigureALL Models SHROUD/WHEELS Procedure REMOVING/INSTALLING the Rear Wheels FigureTurn Power OFF and remove key from ignition REMOVING/INSTALLING the Front Wheels Figure SHROUD/WHEELSModels ZOOM-3 and Lynx SX-3 Models Lynx LX-3 and LX-3 PlusDo not USE TOP Mounting HoleProcedure Transport Transporting the Scooter Figures 1Disassembling the Scooter TransportDetail B Models Built with Delta Tillers Transporting the Scooter for ALL Models Except ZOOM-3Transport Procedure Cable Side ViewDisassembled View Steps 8 and 9 for ALL Models Except ZOOM-3ALL Models Except ZOOM-3 OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Front Basket FigureProcedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Seat Positioning Strap Figure REMOVING/INSTALLING the Floor Basket FigureOPTIONS/REPLACEMENT Parts Procedure REMOVING/INSTALLING the CRUTCH/CANE Holder Figure REMOVING/INSTALLING the Safety Flag FigureOPTIONS/REPLACEMENT PartsANTI-TIPPER Wheel Assembly ANTI-TIPPER WheelsReplacing Seat Lever Figure Replacing Seat LeverReplacing Tiller Angle Adjustment Lever Figure Replacing Headlight LightbulbsModels Lynx LX-3 and Panther LX-4 Figure Lynx LX-3 and Panther LX-4Detail a Back View of Headlight Assembly Model Panther MX-4 FigureReplacing ON-BOARD Battery Charger Figure Replacing ON-BOARD Battery ChargerInvacare Scooters Part No Rev F Limited Warranty Limited W ArrantyOne InvacareWay