Invacare PANTHER MX-4, PANTHER LX-4, LYNX LX-3 REMOVING/INSTALLING the Floor Basket Figure

OPTIONS/REPLACEMENT PARTS PROCEDURE 11

REMOVING/INSTALLING THE FLOOR BASKET (FIGURE 2)

1. To remove, remove the two (2) thumb screws that secure the floor basket in place.

NOTE: The front basket must be installed with angled side facing the front and the vertical side up against the rear shroud.

2.To install, secure basket to front shroud with two (2) thumb screws. Securely tighten.

Thumb	Front	Floor
Screws	Shroud
		Basket
		Rear
Floor		Shroud
		Vertical
Basket
		Side
Front		SIDE VIEW
Shroud
		OF SCOOTER

FIGURE 2 - REMOVING/INSTALLING THE FLOOR BASKET

REMOVING/INSTALLING THE SEAT POSITIONING STRAP (FIGURE 3)

NOTE: To remove, reverse the following procedure.

INSTALLING

1.Remove the width adjustment knob that is located either underneath or on the back of the seat frame.

2.Slide width adjustment knob through grommet on seat positioning strap.

3.Reinstall width adjustment knob into seat frame.

4.Repeat STEPS 1-3 for opposite seat positioning strap.

Width Adjustment

Knob

	Seat Frame
Grommet	Seat Positioning
	Strap

FIGURE 3 -REMOVING/INSTALLING THE SEAT POSITIONING STRAP

OPTIONS/REPLACEMENT PARTS

Part No. 1090132 Rev F 55 Invacare Scooters