SEAT | PROCEDURE 5 |
|
|
NOTE: When installing the seat height adjustment pin, it is necessary to support the weight of the seat assembly.
C.For adjustable seat seat post
4.Reinstall stability knob. Hand tighten.
ADJUSTING THE SEAT HEIGHT
1.Determine seat post type. Refer to DETERMINING SEAT POST TYPE in this procedure of the manual.
2.Perform one (1) of the following:
A.For solid seat posts proceed to SOILD SEAT POSTS in this procedure of the manual.
B.For adjustable height seat posts proceed to ADJUSTABLE SEAT POSTS in this procedure of the manual.
WARNING
DO NOT use the stability knob to adjust the seat height. It is NOT designed to support weight of the user. Otherwise, injury to the user and/or damage to the scooter may result.
SOLID SEAT POST (FIGURE 3)
1.Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in this procedure of the manual.
2.Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD in PROCEDURE 9 of this manual.
3.Remove the batteries w/ cables. Refer to REMOVING/INSTALLING THE BATTERIES WITH CABLES in PROCEDURE 4 of this manual.
4.If necessary, remove the floor basket. Refer to REMOVING/INSTALLING THE FLOOR BASKET in PROCEDURE 11 of this manual.
5.Remove the mounting screw and locknut from the frame post.
SEAT
6.Perform one (1) of the following:
A.For LYNX
B.For LYNX
7.Secure mounting screw in place with EXISTING locknut. Securely tighten.
8.Reassemble scooter by reversing STEPS 1-4.
Stability | Frame Post |
Knob | Mounting |
| Screw |
| Height |
| Adjustment |
| Holes |
Locknut | Front Frame |
Assembly |
NOTE: Tiller assembly, rear frame assembly, and front wheel are not shown for clarity.
FIGURE 3 - ADJUSTING THE SEAT
HEIGHT - SOLID SEAT POSTS
Part No. 1090132 Rev F | 35 | Invacare Scooters |