Invacare LYNX SX-3 Models ZOOM-3 and Lynx SX-3, Models Lynx LX-3 and LX-3 Plus, Do not USE TOP

Page 49

SHROUD/WHEELS

PROCEDURE 9

 

 

REMOVING

1.Turn Power OFF and remove key from ignition.

2.Place the front of the powered scooter up on blocks so that the front wheel is OFF the ground.

3.Remove the hardware that secures the front wheel to the mounting fork/front frame. The hardware for each model is as follows:

A.For ZOOM-3 and LYNX SX-3- Mounting screw, washers and locknut.

B.For Lynx LX-3 and LX-3Plus- Hex head threaded insert, spacers, washer, lockwasher, and locknut.

C.For PANTHER LX-4 and PANTHER MX-4- Mounting screw, lockwasher, washer (if applicable) and locknut.

4.Remove front wheel from mounting fork/front frame.

INSTALLING

1. Secure the wheel to the mounting fork/front frame in the following manner:

WARNING

Front wheel MUST be mounted in the bottom mounting hole For ZOOM-3 and LYNX SX-3. Otherwise, injury may result.

A.For ZOOM-3 and LYNX SX-3- with mounting screw, washers, and locknut.

B.For LYNX LX-3 and LX-3Plus- with hex head threaded insert, spacers, washer, lockwasher, and locknut.

C.For PANTHER LX-4 and PANTHER MX-4- with mounting screw, lockwasher, washer (if applicable) and locknut.

2.Securely tighten front wheel mounting hardware.

MODELS ZOOM-3 AND LYNX SX-3

MODELS LYNX LX-3 AND LX-3Plus

 

DO NOT USE TOP

Mounting

Mounting

Mounting

Screw

MOUNTING HOLE

Fork

Fork

 

Hex Head

 

Lockwasher

 

Mounting

 

Threaded

 

 

 

Screw

 

Locknut

Washer

Insert

 

Washers

Wheel

 

Wheel

 

 

 

 

Spacer

Spacer

MODELS PANTHER LX-4 AND PANTHER MX-4

 

Washer

 

Panther (MX4)

 

Lockwasher

Front

Mounting

Frame

Screw

Wheel

 

FIGURE 3 - REMOVING / INSTALLING THE FRONT WHEEL(S)

SHROUD/WHEELS

Part No. 1090132 Rev F

49

Invacare Scooters

Image 49
Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications General Warnings General Guidelines ProcedureOperating Information General GuidelinesRamps Procedure General GuidelinesElectrical General Warnings Grounding Instructions Weight LimitationBatteries Rain TestGeneral Guidelines Important Information Percentage of Weight Distribution SAFETY/HANDLINGStability and Balance Always wear your seat positioning strapESCALATORS? Sorry StairwaysStandard Tiller Delta TillerSafety INSPECTION/ Maintenance Safety INSPECTION/MAINTENANCESuggested Maintenance Procedures MaintenanceSafety INSPECTION/MAINTENANCE Procedure Detail a Lubrication Points FigureProcedure Safety INSPECTION/MAINTENANCE Troubleshooting GuideOperation Procedure Control Panel FeaturesALL Scooter Models With Delta or Standard Tillers FigureZOOM-3 Procedure Operation Detail aDelta Tiller Panther MX-4 WWith Delta Tillers Figure Panther MX-4 Scooters onlyDetail F Operation of the Scooter Figures Procedure OperationHand Brake Lever Using the Hand Brake LEVER/BRAKE ARM FigureBrake ARM Delta TillersALL Models Except Panther MX-4 Figure Brake Release LeverPanther MX-4 only Figure Fuse Replacement Reset Circuit BREAKER/FUSE Replacement FigureCircuit Breaker Procedure BATTERIES/CHARGING REMOVING/INSTALLING the Batteries with Cables FigureRemoving BATTERIES/CHARGINGBATTERIES/CHARGING Procedure Recommended Battery TypesReplacing the Batteries Figure BATTERIES/CHARGING Diately Cleaning Battery TerminalsCharging the Batteries Model Battery Charger Power CordON-BOARD Battery Charger Figure Remote Battery Charger FigureBattery Charger Operation Remote and ON-BOARD Battery Charger Operation FigureSeat Procedure REMOVING/INSTALLING the SeatDetermining Seat Post Type Figure SeatProcedure Seat Installing FigureRemoving Figure Solid Seat Post Figure Adjusting the Seat HeightDetail a Adjustable Height Seat Post FigureAdjustment Adjusting the Seat DepthALL Models Except ZOOM-3 Figure Adjusting the Seat Depth Using the Adjustable Seat Slide FigureInstalling REMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion FigureFOLDING/UNFOLDING REMOVING/INSTALLINGBack Figure Back CUSHION/UPHOLSTERY FigureAdjusting the Headrest Adjusting the Back ReclineBack Procedure ALL Models Except ZOOM-3, SX-3 and LX-3 FigureAdjustment Armrest Angle AdjustmentArmrest Width ALL Models Except ZOOM-3 Figure Depth Armrest DEPTH/HEIGHT AdjustmentHeight Figure Tiller Adjustment Tiller Angle AdjustmentProcedure Tiller Adjustment Fold Down Tiller ZOOM-3 FigureFive ALL Other Models FigurePosition Models Built AfterProcedure SHROUD/WHEELS REMOVING/INSTALLING the Rear Shroud FigureALL Models SHROUD/WHEELS Procedure REMOVING/INSTALLING the Rear Wheels FigureTurn Power OFF and remove key from ignition SHROUD/WHEELS REMOVING/INSTALLING the Front Wheels FigureModels Lynx LX-3 and LX-3 Plus Models ZOOM-3 and Lynx SX-3Do not USE TOP Mounting HoleTransporting the Scooter Figures 1 Procedure TransportDisassembling the Scooter TransportTransporting the Scooter for ALL Models Except ZOOM-3 Detail B Models Built with Delta TillersCable Side View Transport ProcedureDisassembled View Steps 8 and 9 for ALL Models Except ZOOM-3ALL Models Except ZOOM-3 OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Front Basket FigureProcedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Seat Positioning Strap Figure REMOVING/INSTALLING the Floor Basket FigureOPTIONS/REPLACEMENT Parts Procedure REMOVING/INSTALLING the Safety Flag Figure REMOVING/INSTALLING the CRUTCH/CANE Holder FigureOPTIONS/REPLACEMENT PartsANTI-TIPPER Wheels ANTI-TIPPER Wheel AssemblyReplacing Seat Lever Replacing Seat Lever FigureReplacing Headlight Lightbulbs Replacing Tiller Angle Adjustment Lever FigureModels Lynx LX-3 and Panther LX-4 Figure Lynx LX-3 and Panther LX-4Model Panther MX-4 Figure Detail a Back View of Headlight AssemblyReplacing ON-BOARD Battery Charger Replacing ON-BOARD Battery Charger FigureInvacare Scooters Part No Rev F Limited W Arranty Limited WarrantyOne InvacareWay