Invacare PANTHER LX-4 REMOVING/INSTALLING the Rear Shroud Figure, Procedure SHROUD/WHEELS

Page 46

TILLER ADJUSTMENT

PROCEDURE 9	SHROUD/WHEELS

This Procedure Includes the Following:

Removing/Installing the Rear Shroud

Replacing Foam Filled Tires Onto Wheel Rims

Removing/Installing the Rear Wheels

Removing/Installing the Front Wheel

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise, injury or damage may result.

REMOVING/INSTALLING THE REAR SHROUD (FIGURE 1)

REMOVING

NOTE: To install rear shroud, reverse this procedure.

1.Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in PROCEDURE 5 of this manual.

CAUTION

SLOWLY remove rear shroud on PANTHER MX-4. Wiring harness for taillights is still connected to the bat- tery harness. Otherwise, damage may result.

2.PANTHER MX-4 MODELS - Slowly remove the rear shroud and place on floor close to the scooter. Disconnect taillight wiring harness from battery wiring harness.

PANTHER MX-4

	Rear Shroud
	Battery
	Wiring	Taillight
	Harnes	Taillight
	Harnes	Wiring
		Wiring
		Harnes

	3. ALL MODELS - Lift the rear shroud
		ALL MODELS
	off of the frame post.

REPLACING FOAM FILLED TIRES ONTO WHEEL RIMS

WARNING

This procedure MUST be per- formed by a qualified technician.

NOTE: During initial use of scooter, user may experience flat spot on wheels. Flat spot will vanish with continuous use of scooter.

Rear Shroud

Frame

Post

FIGURE 1 - REMOVING/

INSTALLING THE REAR SHROUD

Invacare Scooters

46

Part No. 1090132 Rev F

Image 46

Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications Operating Information General Guidelines ProcedureGeneral Warnings General GuidelinesRamps Procedure General GuidelinesElectrical Batteries Weight LimitationGeneral Warnings Grounding Instructions Rain TestGeneral Guidelines Important Information Stability and Balance SAFETY/HANDLINGPercentage of Weight Distribution Always wear your seat positioning strapStairways ESCALATORS? SorryDelta Tiller Standard TillerSafety INSPECTION/MAINTENANCE Safety INSPECTION/ MaintenanceSuggested Maintenance Procedures MaintenanceSafety INSPECTION/MAINTENANCE Procedure Lubrication Points Figure Detail aTroubleshooting Guide Procedure Safety INSPECTION/MAINTENANCEALL Scooter Models Control Panel FeaturesOperation Procedure With Delta or Standard Tillers FigureDelta Procedure Operation Detail aZOOM-3 Tiller Panther MX-4 WWith Delta Tillers Figure Panther MX-4 Scooters onlyDetail F Procedure Operation Operation of the Scooter FiguresBrake ARM Using the Hand Brake LEVER/BRAKE ARM FigureHand Brake Lever Delta TillersALL Models Except Panther MX-4 Figure Brake Release LeverPanther MX-4 only Figure Fuse Replacement Reset Circuit BREAKER/FUSE Replacement FigureCircuit Breaker Removing REMOVING/INSTALLING the Batteries with Cables FigureProcedure BATTERIES/CHARGING BATTERIES/CHARGINGBATTERIES/CHARGING Procedure Recommended Battery TypesReplacing the Batteries Figure BATTERIES/CHARGING Cleaning Battery Terminals DiatelyModel Battery Charger Power Cord Charging the BatteriesRemote Battery Charger Figure ON-BOARD Battery Charger FigureBattery Charger Operation Figure Battery Charger Operation Remote and ON-BOARDDetermining Seat Post Type Figure REMOVING/INSTALLING the SeatSeat Procedure SeatProcedure Seat Installing FigureRemoving Figure Adjusting the Seat Height Solid Seat Post FigureAdjustable Height Seat Post Figure Detail aAdjustment Adjusting the Seat DepthALL Models Except ZOOM-3 Figure Using the Adjustable Seat Slide Figure Adjusting the Seat DepthREMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion Figure InstallingBack Figure REMOVING/INSTALLINGFOLDING/UNFOLDING Back CUSHION/UPHOLSTERY FigureBack Procedure Adjusting the Back ReclineAdjusting the Headrest ALL Models Except ZOOM-3, SX-3 and LX-3 FigureAdjustment Armrest Angle AdjustmentArmrest Width ALL Models Except ZOOM-3 Figure Depth Armrest DEPTH/HEIGHT AdjustmentHeight Figure Procedure Tiller Adjustment Tiller Angle AdjustmentTiller Adjustment Fold Down Tiller ZOOM-3 FigurePosition ALL Other Models FigureFive Models Built AfterProcedure SHROUD/WHEELS REMOVING/INSTALLING the Rear Shroud FigureALL Models SHROUD/WHEELS Procedure REMOVING/INSTALLING the Rear Wheels FigureTurn Power OFF and remove key from ignition REMOVING/INSTALLING the Front Wheels Figure SHROUD/WHEELSDo not USE TOP Models ZOOM-3 and Lynx SX-3Models Lynx LX-3 and LX-3 Plus Mounting HoleDisassembling the Scooter Procedure TransportTransporting the Scooter Figures 1 TransportDetail B Models Built with Delta Tillers Transporting the Scooter for ALL Models Except ZOOM-3Transport Procedure Cable Side ViewDisassembled View Steps 8 and 9 for ALL Models Except ZOOM-3ALL Models Except ZOOM-3 OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Front Basket FigureProcedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Seat Positioning Strap Figure REMOVING/INSTALLING the Floor Basket FigureOPTIONS/REPLACEMENT Parts Procedure OPTIONS/REPLACEMENT REMOVING/INSTALLING the CRUTCH/CANE Holder FigureREMOVING/INSTALLING the Safety Flag Figure PartsANTI-TIPPER Wheel Assembly ANTI-TIPPER WheelsReplacing Seat Lever Figure Replacing Seat LeverModels Lynx LX-3 and Panther LX-4 Figure Replacing Tiller Angle Adjustment Lever FigureReplacing Headlight Lightbulbs Lynx LX-3 and Panther LX-4Detail a Back View of Headlight Assembly Model Panther MX-4 FigureReplacing ON-BOARD Battery Charger Figure Replacing ON-BOARD Battery ChargerInvacare Scooters Part No Rev F Limited Warranty Limited W ArrantyOne InvacareWay