Invacare PANTHER MX-4, PANTHER LX-4 Transporting the Scooter Figures 1, Disassembling the Scooter

Page 50

TRANSPORT

PROCEDURE 10

TRANSPORT

This Procedure Includes the Following:

Transporting the Scooter

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise, injury or damage may result.

TRANSPORTING THE SCOOTER (FIGURES 1 AND 2)

DISASSEMBLING THE SCOOTER

NOTE: To reassemble the scooter, reverse the following steps.

1.If applicable, remove the front basket. Refer to REMOVING/INSTALLING THE FRONT BASKET in PROCEDURE 11 of this manual.

2.Fold the back down. Refer to FOLDING/UNFOLDING THE BACK in PROCE- DURE 6 of this manual.

3.Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in PROCEDURE 5 of this manual.

4.FOR ZOOM-3 MODELS ONLY - proceed to STEP 10.

5.Remove the rear shroud. Refer to REMOVING THE REAR SHROUD in PROCEDURE 9 in this procedure of the manual.

6.Remove the batteries with cable assemblies. Refer to REMOVING/INSTALLING THE BAT- TERIES W/CABLES in PROCEDURE 4 of this manual.

7.FOR ALL MODELS EXCEPT ZOOM-3 and PANTHER MX-4, perform the following: (FIGURE 1)

A. For Models Built Without Delta Tillers:

1.Disconnect the BLUE connector of tiller wiring harness from BLUE connector of controller wiring harness (DETAIL "A").

2.Disconnect the YELLOW

connector of tiller wiring harness from YELLOW connector of controller wiring harness (DETAIL "A").

NOTE: In newer models (After 10/00), wiring harnesses from tiller to controller and connectors have been consolidated for ease of use.

B.For Models Built With Delta Tillers:

Disconnect the ORANGE connector of tiller wiring harness from ORANGE connector of controller wiring harness (DETAIL "B").

C.If applicable, remove the tiller wiring harness from the wire supports attached to the controller (DETAIL "A").

Invacare Scooters

50

Part No. 1090132 Rev F

Image 50

Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications Operating Information General Guidelines ProcedureGeneral Warnings General GuidelinesElectrical Procedure General GuidelinesRamps Batteries Weight LimitationGeneral Warnings Grounding Instructions Rain TestGeneral Guidelines Important Information Stability and Balance SAFETY/HANDLINGPercentage of Weight Distribution Always wear your seat positioning strapStairways ESCALATORS? SorryDelta Tiller Standard TillerSafety INSPECTION/MAINTENANCE Safety INSPECTION/ MaintenanceSafety INSPECTION/MAINTENANCE Procedure MaintenanceSuggested Maintenance Procedures Lubrication Points Figure Detail aTroubleshooting Guide Procedure Safety INSPECTION/MAINTENANCEALL Scooter Models Control Panel FeaturesOperation Procedure With Delta or Standard Tillers FigureDelta Procedure Operation Detail aZOOM-3 Tiller Panther MX-4 WDetail F Panther MX-4 Scooters onlyWith Delta Tillers Figure Procedure Operation Operation of the Scooter FiguresBrake ARM Using the Hand Brake LEVER/BRAKE ARM FigureHand Brake Lever Delta TillersPanther MX-4 only Figure Brake Release LeverALL Models Except Panther MX-4 Figure Circuit Breaker Reset Circuit BREAKER/FUSE Replacement FigureFuse Replacement Removing REMOVING/INSTALLING the Batteries with Cables FigureProcedure BATTERIES/CHARGING BATTERIES/CHARGINGReplacing the Batteries Figure Recommended Battery TypesBATTERIES/CHARGING Procedure BATTERIES/CHARGING Cleaning Battery Terminals DiatelyModel Battery Charger Power Cord Charging the BatteriesRemote Battery Charger Figure ON-BOARD Battery Charger FigureBattery Charger Operation Figure Battery Charger Operation Remote and ON-BOARDDetermining Seat Post Type Figure REMOVING/INSTALLING the SeatSeat Procedure SeatRemoving Figure Installing FigureProcedure Seat Adjusting the Seat Height Solid Seat Post FigureAdjustable Height Seat Post Figure Detail aALL Models Except ZOOM-3 Figure Adjusting the Seat DepthAdjustment Using the Adjustable Seat Slide Figure Adjusting the Seat DepthREMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion Figure InstallingBack Figure REMOVING/INSTALLINGFOLDING/UNFOLDING Back CUSHION/UPHOLSTERY FigureBack Procedure Adjusting the Back ReclineAdjusting the Headrest ALL Models Except ZOOM-3, SX-3 and LX-3 FigureArmrest Width Armrest Angle AdjustmentAdjustment Height Figure Armrest DEPTH/HEIGHT AdjustmentALL Models Except ZOOM-3 Figure Depth Procedure Tiller Adjustment Tiller Angle AdjustmentTiller Adjustment Fold Down Tiller ZOOM-3 FigurePosition ALL Other Models FigureFive Models Built AfterALL Models REMOVING/INSTALLING the Rear Shroud FigureProcedure SHROUD/WHEELS Turn Power OFF and remove key from ignition REMOVING/INSTALLING the Rear Wheels FigureSHROUD/WHEELS Procedure REMOVING/INSTALLING the Front Wheels Figure SHROUD/WHEELSDo not USE TOP Models ZOOM-3 and Lynx SX-3Models Lynx LX-3 and LX-3 Plus Mounting HoleDisassembling the Scooter Procedure TransportTransporting the Scooter Figures 1 TransportDetail B Models Built with Delta Tillers Transporting the Scooter for ALL Models Except ZOOM-3Transport Procedure Cable Side ViewALL Models Except ZOOM-3 Steps 8 and 9 for ALL Models Except ZOOM-3Disassembled View Procedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Front Basket FigureOPTIONS/REPLACEMENT Parts OPTIONS/REPLACEMENT Parts Procedure REMOVING/INSTALLING the Floor Basket FigureREMOVING/INSTALLING the Seat Positioning Strap Figure OPTIONS/REPLACEMENT REMOVING/INSTALLING the CRUTCH/CANE Holder FigureREMOVING/INSTALLING the Safety Flag Figure PartsANTI-TIPPER Wheel Assembly ANTI-TIPPER WheelsReplacing Seat Lever Figure Replacing Seat LeverModels Lynx LX-3 and Panther LX-4 Figure Replacing Tiller Angle Adjustment Lever FigureReplacing Headlight Lightbulbs Lynx LX-3 and Panther LX-4Detail a Back View of Headlight Assembly Model Panther MX-4 FigureReplacing ON-BOARD Battery Charger Figure Replacing ON-BOARD Battery ChargerInvacare Scooters Part No Rev F Limited Warranty Limited W ArrantyOne InvacareWay