Invacare PANTHER LX-4, LYNX LX-3 Remote Battery Charger Figure, ON-BOARD Battery Charger Figure

Page 31

BATTERIES/CHARGING	PROCEDURE 4

REMOTE BATTERY CHARGER (FIGURE 3)

1.Open the charger port cover located on the left side of the tiller.

2.Plug charger connector into charger port.

3.Plug charger into standard 110-volt wall outlet.

4.Refer to BATTERY CHARGER OPERATION in this procedure of the manual.

NOTE: Charger Port Covers pivot

LEFT and RIGHT to OPEN

	110-Volt
Charger Port	Wall Outlet
Charger Port	Tiller
Cover

Charger

Connector ChargerAC Power

Port Charger Cord

BATTERIES/CHARGING

FIGURE 3 - CHARGING THE

BATTERIES

(REMOTE BATTERY CHARGER)

ON-BOARD BATTERY CHARGER (FIGURE 4)

1.Remove charger port cover, where applicable.

2.Plug AC power cord into on-board battery charger located underneath floor basket.

3.Plug AC power cord into 110-volt wall outlet.

4.Refer to BATTERY CHARGER OPERATION in this procedure of the manual.

Charger Port	Chain
Cover

On-Board Battery

Charger

Floor Basket

110-Volt

Wall

Outlet

AC Power

Cord

NOTE: On Board Chargers built after 10/00 have a cover attached with a chain to the Floor basket

FIGURE 4 - CHARGING THE

BATTERIES

(ON-BOARD BATTERY CHARGER)

Part No. 1090132 Rev F

31

Invacare Scooters

Image 31

Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications General Guidelines General Guidelines ProcedureGeneral Warnings Operating InformationRamps Procedure General GuidelinesElectrical Rain Test Weight LimitationGeneral Warnings Grounding Instructions BatteriesGeneral Guidelines Important Information Always wear your seat positioning strap SAFETY/HANDLINGPercentage of Weight Distribution Stability and BalanceESCALATORS? Sorry StairwaysStandard Tiller Delta TillerSafety INSPECTION/ Maintenance Safety INSPECTION/MAINTENANCESuggested Maintenance Procedures MaintenanceSafety INSPECTION/MAINTENANCE Procedure Detail a Lubrication Points FigureProcedure Safety INSPECTION/MAINTENANCE Troubleshooting GuideWith Delta or Standard Tillers Figure Control Panel FeaturesOperation Procedure ALL Scooter ModelsTiller Panther MX-4 W Procedure Operation Detail aZOOM-3 DeltaWith Delta Tillers Figure Panther MX-4 Scooters onlyDetail F Operation of the Scooter Figures Procedure OperationDelta Tillers Using the Hand Brake LEVER/BRAKE ARM FigureHand Brake Lever Brake ARMALL Models Except Panther MX-4 Figure Brake Release LeverPanther MX-4 only Figure Fuse Replacement Reset Circuit BREAKER/FUSE Replacement FigureCircuit Breaker BATTERIES/CHARGING REMOVING/INSTALLING the Batteries with Cables FigureProcedure BATTERIES/CHARGING RemovingBATTERIES/CHARGING Procedure Recommended Battery TypesReplacing the Batteries Figure BATTERIES/CHARGING Diately Cleaning Battery TerminalsCharging the Batteries Model Battery Charger Power CordON-BOARD Battery Charger Figure Remote Battery Charger FigureBattery Charger Operation Remote and ON-BOARD Battery Charger Operation FigureSeat REMOVING/INSTALLING the SeatSeat Procedure Determining Seat Post Type FigureProcedure Seat Installing FigureRemoving Figure Solid Seat Post Figure Adjusting the Seat HeightDetail a Adjustable Height Seat Post FigureAdjustment Adjusting the Seat DepthALL Models Except ZOOM-3 Figure Adjusting the Seat Depth Using the Adjustable Seat Slide FigureInstalling REMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion FigureBack CUSHION/UPHOLSTERY Figure REMOVING/INSTALLINGFOLDING/UNFOLDING Back FigureALL Models Except ZOOM-3, SX-3 and LX-3 Figure Adjusting the Back ReclineAdjusting the Headrest Back ProcedureAdjustment Armrest Angle AdjustmentArmrest Width ALL Models Except ZOOM-3 Figure Depth Armrest DEPTH/HEIGHT AdjustmentHeight Figure Fold Down Tiller ZOOM-3 Figure Tiller Angle AdjustmentTiller Adjustment Procedure Tiller AdjustmentModels Built After ALL Other Models FigureFive PositionProcedure SHROUD/WHEELS REMOVING/INSTALLING the Rear Shroud FigureALL Models SHROUD/WHEELS Procedure REMOVING/INSTALLING the Rear Wheels FigureTurn Power OFF and remove key from ignition SHROUD/WHEELS REMOVING/INSTALLING the Front Wheels FigureMounting Hole Models ZOOM-3 and Lynx SX-3Models Lynx LX-3 and LX-3 Plus Do not USE TOPTransport Procedure TransportTransporting the Scooter Figures 1 Disassembling the ScooterTransporting the Scooter for ALL Models Except ZOOM-3 Detail B Models Built with Delta TillersCable Side View Transport ProcedureDisassembled View Steps 8 and 9 for ALL Models Except ZOOM-3ALL Models Except ZOOM-3 OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Front Basket FigureProcedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Seat Positioning Strap Figure REMOVING/INSTALLING the Floor Basket FigureOPTIONS/REPLACEMENT Parts Procedure Parts REMOVING/INSTALLING the CRUTCH/CANE Holder FigureREMOVING/INSTALLING the Safety Flag Figure OPTIONS/REPLACEMENTANTI-TIPPER Wheels ANTI-TIPPER Wheel AssemblyReplacing Seat Lever Replacing Seat Lever FigureLynx LX-3 and Panther LX-4 Replacing Tiller Angle Adjustment Lever FigureReplacing Headlight Lightbulbs Models Lynx LX-3 and Panther LX-4 FigureModel Panther MX-4 Figure Detail a Back View of Headlight AssemblyReplacing ON-BOARD Battery Charger Replacing ON-BOARD Battery Charger FigureInvacare Scooters Part No Rev F Limited W Arranty Limited WarrantyOne InvacareWay