Invacare LYNX LX-3, PANTHER MX-4, PANTHER LX-4 ANTI-TIPPER Wheels, ANTI-TIPPER Wheel Assembly

OPTIONS/REPLACEMENT PARTS PROCEDURE 11

REPLACING ANTI-TIPPER WHEELS AND ANTI-TIPPER WHEEL ASSEMBLY (FIGURE 6)

WARNING

DO NOT operate scooter without the anti-tippers being installed, if so equipped. Anti-tippers MUST BE attached at all times.

ANTI-TIPPER WHEELS

1.Perform one of the following:

A.For ZOOM-3- remove the screw and locknut that secures the anti- tipper wheels to the frame.

B.For all other models - Remove the cotter pin and washer that secure the anti-tipper wheel to the frame.

2.Install NEW wheels and secure with EXISTING hardware.

ANTI-TIPPER WHEEL

ASSEMBLY

NOTE: Anti-tipper wheel assemblies are only found on the LYNX LX-3, LYNX LX-3Plusand

PANTHER LX-4 models.

NOTE: To replace anti-tipper wheels, refer to REPLACING ANTI-TIPPER WHEELS in this procedure of the manual.

1.Remove the quick-release pin that secure the anti-tipper assembly to the rear frame assembly.

2.Remove the anti-tipper wheel assembly.

3.Install NEW anti-tipper wheel assembly.

WARNING

When installing quick-release pin, ensure locking pin is protruding through bottom of sub-frame as- sembly.

4.Secure NEW anti-tipper wheel assembly to sub-frame with quick- release pin.

ZOOM-3

Frame

Locknut

Anti-Tipper

Wheel

Screw

Rear Shroud Cotter Pin

Frame

Anti-Tipper

Wheel

Washer

NOTE: Rear wheel removed for clarity.

Rear

Sub-FrameQuick-

Release

Pin

Anti-Tipper

Assembly

FIGURE 6 - REPLACING ANTI- TIPPER WHEELS AND ANTI- TIPPER WHEEL ASSEMBLY

OPTIONS/REPLACEMENT PARTS

Part No. 1090132 Rev F 57 Invacare Scooters