Invacare PANTHER LX-4, PANTHER MX-4, LYNX LX-3 Adjustable Height Seat Post Figure, Detail a

Page 36

SEAT

PROCEDURE 5

SEAT

 

 

 

ADJUSTABLE HEIGHT SEAT POST (FIGURE 4)

WARNING

Ensure that the seat height adjustment pin is properly engaged and locked. Otherwise, injury and/or damage may result.

DO NOT use the stability knob to adjust the seat height. It is NOT designed to support the weight of the user. Otherwise, injury to the user and/or damage to the scooter may result.

zoom-3

1.Remove the seat. Refer to REMOVING/INSTALLING THE SEAT in this procedure of the manual.

2.Remove the stability knob located on the front of the frame post.

3.Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD in PROCEDURE 9 of this manual.

4.Disengage and remove the seat height adjustment pin from the seat post.

5.Adjust the seat post to the desired height adjustment.

6.Reinstall the seat height adjustment pin through the frame post and seat post.

7.Secure the seat height adjustment pin by performing the following steps:

A.Swivel the pin lock until it is parallel to the pin .

B.Bend the end of the pin lock and position it over the end of the pin (DETAIL "A").

8.Reassemble scooter by reversing STEPS 1-3.

ALL other models

1. Remove the stability knob located on

Adjustable

 

Height Seat

 

the front of the frame post.

 

Post

Seat

 

CAUTION

 

Height

 

Adjust-

When the seat height adjustment pin

 

 

ment Pin

is removed, the weight of the seat

 

 

 

assembly MUST be supported to

Frame

Pin Lock

prevent the seat from falling onto

Post

the frame.

DETAIL "A"

 

2. Disengage and remove the seat height

 

Bend End of

adjustment pin from the seat post.

 

 

Pin Lock AWAY

3. Adjust the seat assembly into the

 

 

From Pin

frame post to the desired height

 

 

adjustment.

FIGURE 4 - ADJUSTING THE SEAT

 

4. While holding the seat assembly in

HEIGHT - ADJUSTABLE HEIGHT

place, install the seat height adjustment

 

SEAT POSTS

pin through the frame post and seat post.

 

 

5.Secure the seat height adjustment pin by performing the following steps:

A.Swivel the pin lock until it is parallel to the pin .

B.Bend the end of the pin lock and position it over the end of the pin (DETAIL "A").

Invacare Scooters

36

Part No. 1090132 Rev F

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications General Guidelines Procedure General WarningsOperating Information General GuidelinesProcedure General Guidelines RampsElectrical Weight Limitation General Warnings Grounding InstructionsBatteries Rain TestGeneral Guidelines Important Information SAFETY/HANDLING Percentage of Weight DistributionStability and Balance Always wear your seat positioning strapStairways ESCALATORS? SorryDelta Tiller Standard TillerSafety INSPECTION/MAINTENANCE Safety INSPECTION/ MaintenanceMaintenance Suggested Maintenance ProceduresSafety INSPECTION/MAINTENANCE Procedure Lubrication Points Figure Detail aTroubleshooting Guide Procedure Safety INSPECTION/MAINTENANCEControl Panel Features Operation ProcedureALL Scooter Models With Delta or Standard Tillers FigureProcedure Operation Detail a ZOOM-3Delta Tiller Panther MX-4 WPanther MX-4 Scooters only With Delta Tillers FigureDetail F Procedure Operation Operation of the Scooter FiguresUsing the Hand Brake LEVER/BRAKE ARM Figure Hand Brake LeverBrake ARM Delta TillersBrake Release Lever ALL Models Except Panther MX-4 FigurePanther MX-4 only Figure Reset Circuit BREAKER/FUSE Replacement Figure Fuse ReplacementCircuit Breaker REMOVING/INSTALLING the Batteries with Cables Figure Procedure BATTERIES/CHARGINGRemoving BATTERIES/CHARGINGRecommended Battery Types BATTERIES/CHARGING ProcedureReplacing the Batteries Figure BATTERIES/CHARGING Cleaning Battery Terminals DiatelyModel Battery Charger Power Cord Charging the BatteriesRemote Battery Charger Figure ON-BOARD Battery Charger FigureBattery Charger Operation Figure Battery Charger Operation Remote and ON-BOARDREMOVING/INSTALLING the Seat Seat ProcedureDetermining Seat Post Type Figure SeatInstalling Figure Procedure SeatRemoving Figure Adjusting the Seat Height Solid Seat Post FigureAdjustable Height Seat Post Figure Detail aAdjusting the Seat Depth AdjustmentALL Models Except ZOOM-3 Figure Using the Adjustable Seat Slide Figure Adjusting the Seat DepthREMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion Figure InstallingREMOVING/INSTALLING FOLDING/UNFOLDINGBack Figure Back CUSHION/UPHOLSTERY FigureAdjusting the Back Recline Adjusting the HeadrestBack Procedure ALL Models Except ZOOM-3, SX-3 and LX-3 FigureArmrest Angle Adjustment AdjustmentArmrest Width Armrest DEPTH/HEIGHT Adjustment ALL Models Except ZOOM-3 Figure DepthHeight Figure Tiller Angle Adjustment Tiller AdjustmentProcedure Tiller Adjustment Fold Down Tiller ZOOM-3 FigureALL Other Models Figure FivePosition Models Built AfterREMOVING/INSTALLING the Rear Shroud Figure Procedure SHROUD/WHEELSALL Models REMOVING/INSTALLING the Rear Wheels Figure SHROUD/WHEELS ProcedureTurn Power OFF and remove key from ignition REMOVING/INSTALLING the Front Wheels Figure SHROUD/WHEELSModels ZOOM-3 and Lynx SX-3 Models Lynx LX-3 and LX-3 PlusDo not USE TOP Mounting HoleProcedure Transport Transporting the Scooter Figures 1Disassembling the Scooter TransportDetail B Models Built with Delta Tillers Transporting the Scooter for ALL Models Except ZOOM-3Transport Procedure Cable Side ViewSteps 8 and 9 for ALL Models Except ZOOM-3 Disassembled ViewALL Models Except ZOOM-3 REMOVING/INSTALLING the Front Basket Figure OPTIONS/REPLACEMENT PartsProcedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Floor Basket Figure REMOVING/INSTALLING the Seat Positioning Strap FigureOPTIONS/REPLACEMENT Parts Procedure REMOVING/INSTALLING the CRUTCH/CANE Holder Figure REMOVING/INSTALLING the Safety Flag FigureOPTIONS/REPLACEMENT PartsANTI-TIPPER Wheel Assembly ANTI-TIPPER WheelsReplacing Seat Lever Figure Replacing Seat LeverReplacing Tiller Angle Adjustment Lever Figure Replacing Headlight LightbulbsModels Lynx LX-3 and Panther LX-4 Figure Lynx LX-3 and Panther LX-4Detail a Back View of Headlight Assembly Model Panther MX-4 FigureReplacing ON-BOARD Battery Charger Figure Replacing ON-BOARD Battery ChargerInvacare Scooters Part No Rev F Limited Warranty Limited W ArrantyOne InvacareWay
Top Page Image Contents