Invacare LYNX SX-3, PANTHER MX-4 Control Panel Features, ALL Scooter Models, Operation Procedure

Page 19

OPERATION

PROCEDURE 3

This Procedure Includes the Following:

Control Panel Features

Operation of the Scooter

Using the Hand Brake Lever/Brake Arm

Brake Release Lever

Reset Circuit Breaker/Fuse Replacement

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely. Otherwise, injury or damage may result.

CONTROL PANEL FEATURES

ALL SCOOTER MODELS

With Delta or Standard Tillers (FIGURE 1).

1.Speed Control Knob - Located on the top face of the control panel. The number one (1) represents the slowest speed and the number ten (10)

represents the fastest speed (DETAIL "A").

2.Battery Charge-Indicator- The charger indicator is located on the top face of the control panel and has an "E" indicating EMPTY and an "F" indicating FULL.

NOTE: The battery charge indicator is composed of eight (8) bars which, when the power is turned on, will illuminate showing the charge level of the batteries. The more number of bars illuminated the more charge the batteries have. See chart below.

NUMBER OF

CHARGE

BARS ILLUMINATED

OF BATTERIES

8

fully charged

 

 

4

partially charged

 

 

0

discharged

 

 

NOTE: The number of bars illuminated may decrease when driving over uneven surfaces even with batteries fully charged. True reading is with key inserted and

indicator illuminated with powered scooter stationary.

WARNING

When negotiating ramps, if the throttle control lever is released while in FORWARD motion the powered scooter will "ROLLBACK" approxi- mately one (1) foot before brake engages. If the throttle control lever is released while in REVERSE motion the powered scooter will "ROLL- BACK" approximately three (3) feet before brake engages.

3. Horn Button - Located on front face of control panel toward the left. (DETAIL "B").

OPERATION

Part No. 1090132 Rev F

19

Invacare Scooters

Image 19
Contents Invacare Scooters Special Notes Table of Contents Procedure 10 Transport Specifications SpecificationsSpecifications General Guidelines General Guidelines ProcedureGeneral Warnings Operating InformationRamps Procedure General GuidelinesElectrical Rain Test Weight LimitationGeneral Warnings Grounding Instructions BatteriesGeneral Guidelines Important Information Always wear your seat positioning strap SAFETY/HANDLINGPercentage of Weight Distribution Stability and BalanceESCALATORS? Sorry StairwaysStandard Tiller Delta TillerSafety INSPECTION/ Maintenance Safety INSPECTION/MAINTENANCESuggested Maintenance Procedures MaintenanceSafety INSPECTION/MAINTENANCE Procedure Detail a Lubrication Points FigureProcedure Safety INSPECTION/MAINTENANCE Troubleshooting GuideWith Delta or Standard Tillers Figure Control Panel FeaturesOperation Procedure ALL Scooter ModelsTiller Panther MX-4 W Procedure Operation Detail aZOOM-3 DeltaWith Delta Tillers Figure Panther MX-4 Scooters onlyDetail F Operation of the Scooter Figures Procedure OperationDelta Tillers Using the Hand Brake LEVER/BRAKE ARM FigureHand Brake Lever Brake ARMALL Models Except Panther MX-4 Figure Brake Release LeverPanther MX-4 only Figure Fuse Replacement Reset Circuit BREAKER/FUSE Replacement FigureCircuit Breaker BATTERIES/CHARGING REMOVING/INSTALLING the Batteries with Cables FigureProcedure BATTERIES/CHARGING RemovingBATTERIES/CHARGING Procedure Recommended Battery TypesReplacing the Batteries Figure BATTERIES/CHARGING Diately Cleaning Battery TerminalsCharging the Batteries Model Battery Charger Power CordON-BOARD Battery Charger Figure Remote Battery Charger FigureBattery Charger Operation Remote and ON-BOARD Battery Charger Operation FigureSeat REMOVING/INSTALLING the SeatSeat Procedure Determining Seat Post Type FigureProcedure Seat Installing FigureRemoving Figure Solid Seat Post Figure Adjusting the Seat HeightDetail a Adjustable Height Seat Post FigureAdjustment Adjusting the Seat DepthALL Models Except ZOOM-3 Figure Adjusting the Seat Depth Using the Adjustable Seat Slide FigureInstalling REMOVING/INSTALLING the Seat UPHOLSTERY/ Cushion FigureBack CUSHION/UPHOLSTERY Figure REMOVING/INSTALLINGFOLDING/UNFOLDING Back FigureALL Models Except ZOOM-3, SX-3 and LX-3 Figure Adjusting the Back ReclineAdjusting the Headrest Back ProcedureAdjustment Armrest Angle AdjustmentArmrest Width ALL Models Except ZOOM-3 Figure Depth Armrest DEPTH/HEIGHT AdjustmentHeight Figure Fold Down Tiller ZOOM-3 Figure Tiller Angle AdjustmentTiller Adjustment Procedure Tiller AdjustmentModels Built After ALL Other Models FigureFive PositionProcedure SHROUD/WHEELS REMOVING/INSTALLING the Rear Shroud FigureALL Models SHROUD/WHEELS Procedure REMOVING/INSTALLING the Rear Wheels FigureTurn Power OFF and remove key from ignition SHROUD/WHEELS REMOVING/INSTALLING the Front Wheels FigureMounting Hole Models ZOOM-3 and Lynx SX-3Models Lynx LX-3 and LX-3 Plus Do not USE TOPTransport Procedure TransportTransporting the Scooter Figures 1 Disassembling the ScooterTransporting the Scooter for ALL Models Except ZOOM-3 Detail B Models Built with Delta TillersCable Side View Transport ProcedureDisassembled View Steps 8 and 9 for ALL Models Except ZOOM-3ALL Models Except ZOOM-3 OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Front Basket FigureProcedure OPTIONS/REPLACEMENT Parts REMOVING/INSTALLING the Seat Positioning Strap Figure REMOVING/INSTALLING the Floor Basket FigureOPTIONS/REPLACEMENT Parts Procedure Parts REMOVING/INSTALLING the CRUTCH/CANE Holder FigureREMOVING/INSTALLING the Safety Flag Figure OPTIONS/REPLACEMENTANTI-TIPPER Wheels ANTI-TIPPER Wheel AssemblyReplacing Seat Lever Replacing Seat Lever FigureLynx LX-3 and Panther LX-4 Replacing Tiller Angle Adjustment Lever FigureReplacing Headlight Lightbulbs Models Lynx LX-3 and Panther LX-4 FigureModel Panther MX-4 Figure Detail a Back View of Headlight AssemblyReplacing ON-BOARD Battery Charger Replacing ON-BOARD Battery Charger FigureInvacare Scooters Part No Rev F Limited W Arranty Limited WarrantyOne InvacareWay