Invacare 1143199 manual Installing Mounting Hardware

SECTION 2—INSTALLING

NOTE: Ensure that the back tab is positioned towards the inside of the wheelchair and the round end is pointing upward.

2.Secure the cane mounting bracket and wedge blocks to the back cane with the two mounting bolts and hex nuts. Hand tighten securely.

NOTE: Some wheelchairs have adjustable back canes that are both 7/8” and 1”. Ensure the wedge blocks are completely on either the 7/8” or 1” section and not straddling the two. Refer to Detail “A” in FIGURE 2.2.

NOTE: It may be necessary to raise or lower the back canes to achieve the desired bracket placement. Refer to Owner’s Manual shipped with wheelchair.

3. Repeat STEPS 1 and 2 for the other cane mounting bracket.

NOTE: Cane mounting brackets MUST be parallel to each other.

4.Using the wrench supplied or 7/16 socket wrench, securely tighten the mounting bolts.

NOTE: DO NOT tighten the mounting bolts until the back height has been adjusted correctly.

NOTE: Check the alignment of the mounting brackets before tightening.

Inside of

Wheelchair

Wedge

Block

Hex Nut

Back Tab

Hex Nut

Cane

Mounting

Back Cane

Outside of

Wheelchair

Mounting Bolts

NOTE: Measure

DETAIL “A” -

ADJUSTABLE BACK

CANES

7/8” section

1” Section

Bracket

Wedge

Block

same distance on both sides.

FIGURE 2.2 Installing Mounting Hardware

InTouch™ Propel™ Back 10 Part No 1143199