SECTION
Adjusting the Propel Back Width
NOTE: For this procedure, refer to FIGURE 2.4.
1.Remove the cushion from the back frame. Refer to Installing/Removing the Propel Back Cushion on page 13.
2.Loosen, but DO NOT remove, the two mounting bolts and washers that secure the cane mounting bracket to the back frame.
3.Move the cane mounting brackets to the desired position.
NOTE: Keep the back frame centered for proper positioning.
4.Carefully set the back onto the back tabs.
5.Adjust the mounting brackets on both sides for desired fit keeping back centered.
6.Tighten the mounting bolts securely.
7.Replace the cushion. Refer to Installing/Removing the Propel Back Cushion on page 13.
8.Check the back height, adjust cane mounting bracket if necessary. Refer to Installing Mounting Hardware on page 9.
NOTE: Most wheelchairs’ back canes are not fully vertical. Adjust the width of the brackets on the back frame to match. If the Propel Back seems too loose or too tight, the brackets can be manually adjusted to increase or decrease the amount of effort required to install or remove the back from the chair. This adjustment may also be used to reduce back noise caused by movement in the wheelchair.
Back Frame
Back Latch Bracket (hidden from view)
Cane Mounting |
|
Bracket | Mounting Bolts |
|
Front
Washers
DETAIL “A” - ADJUSTING
BACK WIDTH
Back
Back Latch Brackets
NOTE: Back canes not shown for clarity.