Philips HX6711 manual Clean and White mode brushing instructions, Brushing modes, Clean mode

	English
	6 Begin brushing in section 1 (outside upper teeth) and brush for
1	30 seconds before you move to section 2 (inside upper teeth).
2	Continue brushing in section 3 (outside lower teeth) and brush for
	30 seconds before you move to section 4 (inside lower teeth).
4
3

7After you have completed the brushing cycle, you can

spend additional time brushing the chewing surfaces of your teeth

and areas where staining occurs.You can also brush your tongue, with the toothbrush switched on or off, as you prefer.

The Sonicare is safe to use on:

- Braces (brush heads wear out sooner when used on braces)

- Dental restorations (fillings, crowns, veneers)

Note:You can switch off the toothbrush at any time by pressing and holding the on/off button for 2 seconds.

Clean and White mode brushing instructions

The Clean and White mode consists of 2 minutes of Clean mode to clean the whole mouth and an additional 30 seconds of White mode to focus on the visible front teeth.

1 Brush the first 2 minutes as instructed in steps 1-6 above.

2 After the 2 minutes of Clean mode, the White mode begins with a change in brushing sound and motion.That is your signal to start brushing the visible upper front teeth for 15 seconds

3At the next beep and pause, move to the visible lower front teeth for the final 15 seconds of brushing.

Brushing modes

The Sonicare automatically starts in the default Clean mode.To select a different brushing mode:

1Press the on/off button to toggle between modes.

,The green LED indicates the selected mode.

Note:You can only switch between modes when the toothbrush is switched on.

Clean mode

Standard mode for superior teeth cleaning.

Sensitive mode (specific types only)

Gentle yet thorough cleaning for sensitive gums and teeth.

Clean and White mode

2 minutes of Clean mode with an additional 30 seconds of White mode to focus on the visible front teeth.

Note:When the Sonicare is used in clinical studies, the default 2-minute Clean mode must be selected. However, in whitening/stain reduction studies, the Clean and White mode must be selected.The handle should be fully charged and the Easy-start feature deactivated.