ClearSounds V608 manual Playback through handset receiver +40dB volume, Delete Incoming Messages

of a message press the PLAY button and the message will pause (max. 7 seconds). Press PLAY again to resume playback.

2When playback is finished you will hear two short beeps, and the machine will return to standby mode. All incoming messages are saved (unless you have erased any during playback, see below), new messages will then be recorded after the old ones.

The following functions are available during playback: Button Function

SKIP	Skip to next message.
REPEAT	Repeats the current message, or hold down until you
	hear a beep to step back through the messages
ON/OFF	Stop playback.
DELETE	Erase messages.

Playback through handset receiver

(+40dB volume)

To playback your messages, pick-up the handset and press PLAY, now you can press the +40dB BOOST key to boost the message volume to 40dB.

Delete Incoming Messages

If you want to delete a single incoming message press DELETE while the message is playing.

To erase all messages after playback, press and hold DELETE until unit beeps.

Please note that new messages cannot be deleted until they have been played.

Call Screening

Incoming messages can be heard through the Speakerphone as they are received. If there is no sound adjust the volume using the control on the right side of the phone.

You can lift the handset to speak directly to the caller. If the recording does not stop automatically, press ON/OFF on the answering machine, or press * (2 seconds) on the telephone.

Checking your messages from a remote

location.

This machine can be remotely controlled using the keys of an ordinary tone dialing telephone. Call up the answering machine and enter the remote code while the outgoing message is playing. Once the code is accepted, several remote control commands are available.

10 – ENGLISH