ClearSounds V608 manual Remote Code, Remote Control, During playback, After playback

Remote Code

This three-digit remote code is required in order to gain access to the remote functions of the answering machine. The remote code is printed underneath the machine.

Remote Control

1Call up the answering machine.

2While the outgoing message is playing, enter the remote code. If the code is accepted, you will hear two beeps.

3Select a remote control command (within 20 seconds) from below.

4 When you have finished accessing the machine replace the handset.

	Command Functions
25	Play new messages
2#	Play all messages
	During playback:
3#	Erase single message during playback
6#	Skip to previous message
7#	Skip to next message
8#	Repeat message
##	Stop playback
	After playback:
3#	Erase all messages
7#	Record a new outgoing message, to Stop
	recording press 7#again.
8#	Record a MEMO, to Stop recording press 8#
	again.
9#	Turn the answering machine either On or Off.
	Three beeps indicate Off- Two beeps indicate On.
0#	Room monitor, press 5# to stop the room
	monitoring.

NOTE: If the machine doesn’t respond correctly to the remote control commands, try pressing the telephone buttons for a longer or shorter time. In normal cases, the answering machine should react to tones approximately 0.5 – 1 seconds in length, but longer tones may be necessary. If you do not enter any remote control command, the answering machine will disconnect after a few seconds.

If you listen to any incoming messages for more than 2 minutes and

11 – ENGLISH