Sprint Nextel SP7084 owner manual TAD Operation, Recording Greetings, Reviewing the Greetings

Page 30

43-5708.fm Page 30 Monday, September 18, 2000 7:56 AM

ˆTAD Operation

Each station has its own TAD (Telephone Answering Device) and can play up to six greetings. The total recording time is about 28 minutes, including the outgoing greet- ing(s).

All six greeting memories have the same prerecorded message, “Please record a message after the tone.” You can record your own greeting in any of the six memo- ries. If you intend to use the call routing fea- ture, you must record personalized greetings to direct your callers.

Greetings can be set up to:

greet the caller

provide specific information

allow the caller to record a message

route a call

announce a message only and not allow the caller to leave a message

You can also select different greetings to play during specified times. See “Setting the Greeting Timer” on Page 32.

Important: For the TAD to work, Auto Atten- dant must be turned on (see “Auto Attendant Operation” on Page 28).

RECORDING GREETINGS

1.Press PROGRAM.

2.Select ANSW.

3.Select NEXT twice until GREETING SETUP appears.

4.Select ENTER. RECORD GRT appears.

5.Select ENTER. If necessary, repeatedly select NEXT to display the desired greeting number.

6.Select ENTER to begin recording your greeting. RECORDING 1 appears and you hear, “Please record a new greeting (number),” followed by a beep.

After the beep, say your message clearly, about eight inches from the microphone.

7.Select STOP when you finish recording. The greeting automatically plays.

8.Select NEXT until the next greeting number you want to record appears.

9.Repeat Steps 6 to 8 to continue record- ing additional greetings.

10.Press PROGRAM to exit.

When all desired greetings have been re- corded, you must:

select which greeting answers all incom- ing calls (see “Selecting the Primary Greeting” on Page 31)

select whether callers can leave mes- sages on the unit (ANSWER), or if all callers can only hear messages and not leave messages (ANNOUNCE ONLY) (see “Setting the Greeting Mode” on Page 31)

Reviewing the Greetings

You can listen to your recorded greetings at any time.

Note: If no greeting is recorded, you hear “Please record a new greeting.”

1.Press PROGRAM.

30

TAD Operation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 30
Contents SP708 4-Line Phone System Contents Memory Operation Troubleshooting Features TAD Telephone Answering Device FeaturesRead this Before Installation FCC StatementFCC Wants YOU to Know Important Safety Instructions LightningFm Page 8 Monday, September 18, 2000 756 AM Quick Look at Your Phone Non-Square Configuration Private Line Support InstallationSquare Configuration Planning Your SystemMounting the System On a DeskOn a Wall or Wall Plate Battery Power Levels Installing the Backup BatteriesConnecting the AC Adapter Attaching the HandsetConnecting a FAX or PC Modem Setting UP the Stations Verifying the Station and Line ConfigurationsPreparation Setting the Private Line Verifying System ConfigurationStation Reset Setting the RingerSetting Always Ring Setting the HANDSET, Headset and Speaker VolumeSetting the Ringer Volume Handset/Headset VolumeUsing a Headset Telephone OperationMaking Calls Conference Calling with Two Outside Lines Answering CallsTransferring Calls Answering a Call While You Are On Another LineUsing Hold Using Auto RedialUsing Flash With AnnouncementUsing Mute Using the IntercomPaging All Stations Using Standard Phones with the SystemUsing Automatic Answer Monitoring Other RoomsEntering a Pause Memory OperationStoring a Name and Number in Memory Editing Stored NumbersDialing a Stored Number Chain-Dialing Service NumbersTesting Stored Emergency Numbers Deleting Stored NumbersCaller ID Operation Programming Caller IDReviewing Caller ID Records Dialing Numbers from a Caller ID RecordCaller ID Messages Storing a Caller ID Record in Memory Deleting RecordsCaller ID Operation with Auto Attendant on Auto Attendant Operation Assigning AN Auto Attendant StationTurning OFF Auto Attendant Auto Attendant Station OperationTAD Operation Recording GreetingsReviewing the Greetings Setting the Greeting Mode Selecting the Primary GreetingSelecting the Number of Rings Setting the TAD to Answer CallsSetting the Greeting Timer Call ScreeningRecording Incoming Messages Recording a MemoRecording a Conversation Playing MessagesDeleting Messages Programming a Remote Access CodeUsing Remote Access Remote OperationTroubleshooting Problem SolutionTroubleshooting Performing a System Update Resetting the Time and DateCare Limited One-Year Warranty