Xantrex Technology 809-0912 manual Circuit Configuration, Circuit Priority, Config Circuit

FSequence IPM Owners Guide.book Page 17 Thursday, October 6, 2011 3:33 PM

		Basic Configuration Settings
Circuit Configuration	Each circuit has settings that can be configured individually.
	•	Priority – a numerical circuit priority designation from 1 to 101.
The circuit configuration screen displays five circuits at a time (see		This setting will allow a circuit to be re-prioritized. 1 is highest priority
“Freedom Sequence Basic Configuration Screen” on page 11).		and 10 is the lowest priority.

FSPM 00: Status		FSPM 00: Config
L2 Amps	On 0.0A	Mode			[Operating]
Batt Voltage	12.8V	SHR	BKR	Mode	[Manual]
Circuit Status		SHR	BKR	Rating	[25.0A]
Config		Circuit		Config

•Load Shed – can be set to Disabled or Enabled.

This setting will allow a circuit to be subjected to load shedding or not.

IMPORTANT: When reprogramming default circuit priority settings, always consult a professional installer from your RV dealership.

	2 Press to activate	1 Press down until the
	the screen.	field is selected.
FSPM 00: Circuit Config
1	ACLoad1
1	Priority	[1]
1	Load Shed	[Disabled]
2	ACLoad2

5Scroll up and down to view each circuit configuration.

4 Press to display 3 Scroll down until

the circuit level Circuit Config is

settings. selected.

Circuit Priority

Each AC relay of the power manager that is configured to control an AC load circuit is assigned a priority number. The power manager uses this priority number in a ranking order to control the load shed order or load disconnect order in the event that an AC load demand exceeds the shore or generator breaker capacity. See “AC Load Shedding” on page 34 for more information. A priority of “1” is equivalent to the highest priority, therefore, it is the last to be shed in an overload condition. Conversely, a priority of “10” is the lowest priority and the first to be shed.

1.1 to 8 for the Freedom Sequence four-circuit model PN: 809-0913.

975-0593-01-01 17