Xantrex Technology 809-0912 manual To change the priority setting from the Device Status screen

FSequence IPM Owners Guide.book Page 18 Thursday, October 6, 2011 3:33 PM

Basic Configuration Settings

AC Relays	To change the priority setting from the Device Status screen:
By default, each AC load circuit is assigned a priority number in the factory			FSPM 00: Config
(ACLoad1 = 1 up to ACLoad6 = 61), which can be changed via SCP on the	FSPM 00: Status
Circuit Config screen. The priority order is then automatically swapped	L2 Amps	On 0.0A	Mode	[Operating]
as explained in “Priority Swapping Between Circuits” on page 37.	Batt Voltage	12.8V	SHR BKR Mode	[Manual]
	Circuit Status		SHR BKR Rating	[25.0A]
How the power manager uses the priority number to determine the load-	Config		Circuit Config
shedding order of AC circuits is explained in “AC Load Shedding” on page
34.
	2 Press to activate	1 Press down until the	4 Press to display 3 Scroll down until Circuit
	the screen.	field is selected.	the screen.	Config is selected.

DC Relays

DC Relays are not assigned a priority, but if a DC relay is associated to either Line1 or Line2, it will assume the lowest priority ranking in the system.

If association of a DC Relay is changed from Line1 or Line2 to Batt1, it will lose any priority value and the power manager will re-organize the priority numbers for the rest of the relays.

FSPM 00: Circuit ConfigFSPM 00: Circuit Config

1	ACLoad1		1	ACLoad1
1	Priority	[1]	1	Priority	[*1]
1	Load Shed	[Disabled]	1	Load Shed	[Disabled]
2	ACLoad2		2	ACLoad2
	6 Press to	5 Scroll up or down to select a		8 Press to	7 Scroll up and down to
	change.	circuit priority setting.		confirm the	choose a value.
				selected value.
FSPM 00: Circuit Config
1	ACLoad1
1	Priority	[2]
1	Load Shed	[Disabled]
2	ACLoad2

1.For the four-circuit Freedom Sequence model, AC circuits are ACLoad1 up to ACLoad4. DC circuits are from DCLoad1 up to DCLoad4.

18 Freedom Sequence Intelligent Power Manager Owner’s Guide