Xantrex Technology 809-0912 manual Circuit Type, AC Line

FSequence IPM Owners Guide.book Page 30 Thursday, October 6, 2011 3:33 PM

Circuit Level Advanced Settings

Load Shed

The Load Shed setting here is the same as the setting discussed in “Load Shed” on page 19. The only difference here is that the change in load shed setting happens from the circuit-level screen in Advanced Settings instead of from the Config screen.

Circuit Type

The Freedom Sequence power manager’s circuit relays can control either AC or DC lines. If the circuit relay controls an AC line, its type is ACInputOut. If the circuit relay controls a DC line, its type is DCInputOut. AC relay types cannot be modified to DCInputOut. However, a DC relay type can be modified to ACInputOut when that DC relay is used to control an AC appliance.

Model	AC Relays	Types	DC Relays	Types
Four-Circuit	Circuit1,	ACInputOut	Circuit5,	DCInputOut
Freedom	Circuit2,	(default, cannot	Circuit6,	(default)
Sequence	Circuit3,	be modified)	Circuit7,	or
	Circuit4		Circuit8
				ACInputOut
Six-Circuit	Circuit1,	ACInputOut	Circuit7,	DCInputOut
Freedom	Circuit2,	(default, cannot	Circuit8,	(default)
Sequence	Circuit3,	be modified)	Circuit9,	or
	Circuit4,		Circuit10
	Circuit5,			ACInputOut
	Circuit6

AC Line

AC Relays All AC relays can be associated to either Line1 or Line2. This is called Line Association. You may assign certain AC relays to Line1 and the remaining AC relays to Line2. For example, Circuit1, Circuit3, and Circuit5 can be assigned to Line1 and Circuit2, Circuit4, and Circuit6 can be assigned to Line2. Default settings are shown below.

DC Relays When the type of load circuit is changed from DC to AC, the line association can either be Line1 or Line2. Default settings are shown below.

NOTE: DC relays can be used to control AC loads. For example, a DC relay can be used to signal an external AC contactor/relay to control an external AC load circuit.

Model	AC Relays	Line Association	DC Relays	DC Conn
		[Default]		[Default]
Four-Circuit	Circuit1,	[Line1]	Circuit5,	[Line1]a
Freedom	Circuit2		Circuit6
Sequence	Circuit3,	[Line2]	Circuit7,	[Line1]a
	Circuit4		Circuit8
Six-Circuit	Circuit1,	[Line1]	Circuit7,	[Line1]a
Freedom	Circuit2,		Circuit8
Sequence	Circuit3
	Circuit4,	[Line2]	Circuit9,	[Line1]	a
	Circuit5,		Circuit10
	Circuit6

a.If the Type is changed to ACInputOut.

NOTE: This setting can only be modified when Mode is set to Standby.

30 Freedom Sequence Intelligent Power Manager Owner’s Guide