Xantrex Technology 809-0912 To change the Load Shed from the Device Status screen, Enabled

FSequence IPM Owners Guide.book Page 19 Thursday, October 6, 2011 3:33 PM

Basic Configuration Settings

Load Shed	To change the Load Shed from the Device Status screen:
Load circuits controlled by AC-only relays can be forced to remain ON and	FSPM 00: Status		FSPM 00: Config
	L2 Amps	On 0.0A	Mode	[Operating]
exempt themselves from the load shedding logic of the Freedom Sequence
	Batt Voltage	12.8V	SHR BKR Mode		[Manual]
power manager. This exemption technique is useful when you want to keep	Circuit Status		SHR BKR Rating		[25.0A]
one or two loads running at the expense of other loads in the system that	Config		Circuit Config
remain subject to the load shedding logic. If the Load Shed setting is
Disabled, this can be interpreted as rendering the load circuit “invisible”
from the power system. Thus, the power manager cannot apply the load	2 Press to activate 1 Press down until the		4 Press to display		3 Scroll down until Circuit
shedding logic to this circuit but can still apply to the other loads “visible”
	the screen.	field is selected.	the screen.		Config is selected.
to the power manager. Therefore, the user should be careful to change this	FSPM 00: Circuit Config		FSPM 00: Circuit Config
setting back to Enabled since this is not done automatically.	1 ACLoad1		1 ACLoad1
By default, the Load Shed setting of all the AC and DC relays is set to	1 Priority	[2]	1 Priority		[2]
	1 Load Shed	[Enabled]	1 Load Shed		[*Enabled]
Enabled.	2 ACLoad2		2 ACLoad2
	6 Press to	5 Scroll up or down to select a	8 Press to	7 Scroll up and down to
	change.	load shed setting.	confirm the	choose a value.
	FSPM 00: Circuit Config		selected value.
	1 ACLoad1
	1 Priority	[2]
	1 Load Shed	[Disabled]
	2 ACLoad2

975-0593-01-01 19