Xantrex Technology 809-0912 manual Circuit Name, Circuit3

FSequence IPM Owners Guide.book Page 29 Thursday, October 6, 2011 3:33 PM

Circuit Level Advanced Settings

Circuit Name

All the AC and DC relays of Freedom Sequence can be assigned a circuit name1 (a label) from the Xanbus SCP or XDT2 tool. The label for each of these relays can be up to ten alpha-numeric characters.

The benefit of labelling the relays are for customizing and ease of use.

Relay ID	Default Circuit Name	Possible New Name
Circuit1	ACLoad1	Main-A/C
Circuit2	ACLoad2	Space-heat
Circuit3	ACLoad3	Dishwasher
Circuit4	ACLoad4	Refrigerat
Circuit5	ACLoad5	H2O-Heater
Circuit6	ACLoad6	WallOutlet
Circuit7	DCLoad1	Thermostat
Circuit8	DCLoad2	and so on...
Circuit9	DCLoad3
Circuit10	DCLoad4

To change the Circuit Name from the Advanced Settings screen:

1.Press the Enter button to activate the circuit setup screen for the selected circuit.

2.Press the Enter button on the Circuit Name field.

3.Press the Func button to erase the characters one by one, except the last character. Erasing all characters will put you back to step 2.

4.Use the arrow buttons to scroll through the character set.

5.Press the Enter button to confirm a character selection. Repeat 4 and 5 to form a new circuit name, up to ten characters.

6.Press the Enter button again on the last character to confirm the new circuit label.

1.Circuit names can be up to ten characters long. Valid characters are from a to z, A to Z, 0 to 9, symbols '/' (forward slash) and '-'(hyphen). Spaces, underscore and period are not accepted symbols. 2.The XDT tool is available for OEMs only.

FSPM 00: Advanced Settings	FSPM 00: Circuit 3
Circuit1	Circuit Name		[ACLoad3]
Circuit2	Over-ride		[Disabled]
Circuit3	Type	[ACInputOut]
Circuit4	Line Association		[Line1]

1					2
FSPM 00: Circuit 3						FSPM 00: Circuit 3
Circuit Name		[ACLoad	2	]		Circuit Name		[	D	]
Over-ride		[Disabled]				Over-ride		[Disabled]
Type	[ACInputOut]					Type	[ACInputOut]
Line Association		[Line1]				Line Association		[Line1]

		3			5		4
FSPM 00: Circuit 3						FSPM 00: Circuit 3
Circuit Name	[Dishwashe		r	]		Circuit Name	[Dishwasher]
Over-ride		[Disabled]				Over-ride		[Disabled]
Type	[ACInputOut]					Type	[ACInputOut]
Line Association		[Line1]				Line Association		[Line1]

6

NOTE: This setting can only be modified when Desired Mode is set to Standby.

975-0593-01-01 29