Xantrex Technology 809-0912 manual Circuit Status

FSequence IPM Owners Guide.book Page 10 Thursday, October 6, 2011 3:33 PM

Circuit Status

In the Circuit Status screens, no item is configurable. This means that the screens are only useful for up-to-date information on each circuit.

	1				2
		FSPM 00: Circuit Status
					4
3		1	ACLoad1	On 3.0A
		1	Last Shed Current	2.0A		5
		2	ACLoad2	On 4.5A
		2	Last Shed Current	4.0A

FSPM 00: Circuit Status
6	ACLoad6	On 3.0A
6	Last Shed Current		4.0A
7	DCLoad7		On N/A	6
7	Last Shed Current		5.0A
8	DCLoad8		On
8	Last Shed Current		.5A
9	DCLoad9		On N/A
9	Last She Current		N/A
10 DCLoad10			On N/A	7
10 Last Shed Current			N/A

1Circuit names can be up to ten characters long. Valid characters are from a to z, A to Z, 0 to 9, symbols '/' (forward slash) and '-'(hyphen). Spaces, an underscore, and a period are not accepted symbols. Examples are “Main-A/ C” and “Refrigerat”.

2Indicates whether the circuit is currently enabled (ON) or not (Off).

3This number corresponds to the AC circuit ID label found on the product, like AC 1 is 1, AC 2 is 2, et cetera. 7 to 10a refer to the four DC relays.

4Indicates the current (in amps) presently passing through the circuit. It displays 0.0A if no AC current is passing through. It will always display N/A for all DC relays. See #6 and #7.

5Last Shed Current indicates the last value of the current (in amps) for the circuit before the circuit was shed in a load shedding event.

6In this example, Circuits 7 and 8 are DC relays controlling AC loads. This means that both these circuits will each display a Last Shed Current value that is dependent on the AC load that each are controlling.

7In this example, Circuits 9 and 10 are DC relays controlling DC loads. DC relays that control DC loads are not monitored for amperage, thus, their statuses are N/A and there are no Last Shed Current values.

a.5 to 8 for the Freedom Sequence four-circuit model PN: 809-0913.

10 Freedom Sequence Intelligent Power Manager Owner’s Guide