Avaya 555-233-128 manual Dhcp Processing, Waiting for, Authentication

Page 38

4600 Series IP Telephone Installation

3.Enter the 802.1X password using up to 12 numeric characters and press #.

Note:

For security purposes, an asterisk displays in place of each digit entered.

4.The telephone displays the following:

Waiting for 802.1X

authentication...

5.If authentication is successful, the telephone stores a new ID and password in reprogrammable non-volatile memory, and starts the DHCP process. If unsuccessful, the telephone displays a failure message and repeats the authentication process from Step 1.

DHCP Processing

The IP telephone sends a request to the DHCP server and invokes the DHCP process.

1. The telephone displays one of the following messages:

DHCP: s secs

# to program

DHCP: s secs VLAN ID = n

DHCP: s secs

where s is the number of seconds that have elapsed since DHCP was invoked. The message on the left appears if 802.1Q tagging is off and access to local programming procedures is not disabled or restricted. (See Chapter 3: Local Administrative Options for specifics.) The middle message appears if 802.1Q tagging is on and access to local programming procedures is disabled or restricted. If the left and middle messages alternate every two seconds, 802.1Q tagging is on. When both messages alternate, access to local programming procedures is not disabled or restricted. Finally, the message on the right appears if 802.1Q tagging is off and access to local programming procedures is disabled or restricted.

2.The DHCP server provides IP Addresses for the following hardware:

●The IP telephone

●The TFTP or HTTP server

●The TN799B, C, or D Control-LAN (C-LAN) circuit pack on the media server (for IP telephones supporting H.323 protocol)

The 4601 and 4601+ cannot display messages. Therefore, if the DHCP process locates the required information, the 4601’s Call Appearance Line b indicator flashes continuously 500 milliseconds on, 500 milliseconds off while all other LEDs remain lit. If the appropriate information cannot be discerned or is missing, the 4601’s Call Appearance Line a indicator flutters 50 milliseconds on, 50 milliseconds off three times while all other LEDs remain lit, and a reset occurs.

38 4600 Series IP Telephone Installation Guide

Image 38

Contents Series IP Telephone Installation Guide Avaya Inc All Rights Reserved Introduction Local Administrative Options Index 103 Contents Series IP Telephone Installation Guide About This Guide IP Telephone Model H323 Protocol Supported?Document Organization Installation GuideIntended Audience Change History What’s New in This Release FilterlistTerms Used in This Guide Conventions Used in This Guide Symbolic ConventionsCommand Typographic ConventionsAvaya Communication Manager Software Documentation Release Online DocumentationRelated Documents Series IP Telephone Safety Instructions Administrator Guide for Avaya Communication ManagerAvaya IP Telephone Snmp Security White Paper, Issue 30A Switched Hub Set Up Quick Reference, Issue 2, July 20024602/4602SW IP Telephone User Guide Series IP Telephone LAN Administrator GuideIP Telephone User Guide 4602/4602SW SIP IP Telephone User GuideCustomer Support Administrator Guide IntroductionIP Telephone Models SoftwareMedia Server Avaya IP IP Telephone Release Pre-Installation ChecklistRequirements to Verify about the Network Except20 4600 Series IP Telephone Installation Guide Requirements to Verify for Each IP Telephone Optional Items for Some IP TelephonesPowering the 4600 IP Telephone Assembling the 4600 Series IP TelephoneTelephone Model See Connection Jacks on a 4606/4612/4624 IP Telephone Assembling the 4600 Series IP Telephone 26 4600 Series IP Telephone Installation Guide = optional Facultatif DSS 4624 optionale Opcional 28 4600 Series IP Telephone Installation Guide Assembling the 4600 Series IP Telephone Connection Jacks on a 4630 IP Telephone Connection Jacks on a 4630SW IP Telephone Option a Connection Jacks on a 4630SW IP Telephone Option B Connection Jacks on a 4610SW IP Telephone Option a Connection Jacks on a 4610SW IP Telephone Option B Connection Jacks on a 4690 IP Conference Telephone Dynamic Addressing Process Ethernet Activation 802.1X Supplicant AuthenticationPassword= #=OK 802.1X ID=ddd #=OK New=Waiting for AuthenticationDhcp Processing Dhcp s secs # to program Dhcp s secs Vlan ID = nHttp n uri 46xxUPGRADE.SCR n KB receivedTFTP/HTTP Processing Saving to flash 1%, 1 secs Media Server RegistrationFilename KB received Extension=nnnnnn #=OK NEW=Downgrading Avaya IP Telephones H.323 Only Converting Software on Avaya 4600 Series IP Telephones Displays Enter command Converting 4602+/4610SW/4620SW/4621SW IP TelephonesInformation, see Signaling Protocol Unnamed Registration 802.1X Supplicant Operation46 4600 Series IP Telephone Installation Guide Local Administrative Options Entering Data for Administrative Options Conference button IP Telephone # Backspace AlternativeSpeaker button Headset buttonEntering Data for the 4601 IP Telephone About Local Administrative Procedures Local Programming Option Code SeeE a R Mute 8 0 2 1 9 # Mute 8 0 2 1 x # Set the 802.1X Operational Mode802.1X=setting *=change #=OK Save new value? =no #=yesPre-Installation Checklist for Static Addressing Static Addressing InstallationNnn.nnn.nnn.nnn Phone= Phone=nnn.nnn.nnn.nnnNew= CallSv=nnn.nnn.nnn.nnnCallSvPort=nnnnn New= 802.1Q=off 1=on #=OK 802.1Q=on 0=off #=OKSave new values? *=no #=yes Vlan ID=dddd New=Vlan test=ddd New= New values being savedHandset AGC=on 0=off #=OK Handset AGC=off 1=on #=OK Disable/Enable Automatic Gain ControlMute 2 4 2 # Mute a G C # Headset AGC=on 0=off #=OK Headset AGC=off 1=on #=OKMute 2 5 3 7 8 # Mute a L E R T # Visual/Audible Alerting ProcedureAlerting=setting *=change #=OK 60 4600 Series IP Telephone Installation Guide Chaddr=dddddd New= Manually Setting the Dhcp Client Hardware AddressMute 2 4 2 3 3 7 # Mute C H a D D R # Clear Procedure Are you sure? =no #=yes Mute 2 5 3 2 7 # Mute C L E a R #Clear all values? =no #=yes Clearing values= 0=+ #=OK Adjusting the Contrast ControlMute 2 6 6 8 # Mute C O N T # Mute 2 8 4 # Mute C T I # Computer-Telephony Integration CTI Enable/DisableCTI=manual 0=Off #=OK CTI=disabled 1=Manual #=OK UDP Port=497xx New=FKEU=on 0=Off #=OK FKEU=off 1=Manual #=OK Enabling/Disabling the Fkeu Xmod InterfaceMute 3 5 3 8 # Mute F K E U# Save new values? =no #=yesMute 4 7 6 8 7 Mute G R O U P Group IdentifierNo new values? #=OK Group=ddd New=PHY1=status *=change #=OK Interface ControlMute 4 6 8 # Mute I N T # PHY2=status *=change #=OK IR=enabled 0=disable #=OK IR=disabled 1=enable #=OK Log=status *=change #=OK Disable/Enable Event LoggingMute 5 6 4 # Mute L O G # Mute 5 6 4 6 3 3 # Mute L O G O F F # Login Enter Extension Enter Extension and press Enter or OKLogoff Mute 6 3 3 # Mute O F F # QoS Option SettingTurning Off the Backlight Mute 7 6 7 # Mute Q O S #L3 audio=dd New= L2 signaling=d New=L3 signaling=dd New= No new values. #=OKMute 7 3 7 3 8 # Mute R E S E T # Reset System ValuesReset values? *=no #=yes Are you sure? *=no #=yesRestart phone? =no #=yes Resetting valuesRestart the Telephone Signaling Protocol Identifier Mute 7 4 4 Mute S I GSIG=protocol *=change #=OK SSON=ddd New= Site-Specific Option Number SettingMute 7 7 6 6 # Mute S S O N # Setting L2Q Tagging Control 4601 Only Mute 8 2 4 # Mute T a G #Self-Test Procedure Mute 8 3 7 8 # Mute T E S T #Self test failed #=end Self test #=endSelf test passed #=end Troubleshooting Guidelines Error ConditionsPower Interruption Dtmf Tones46ccDccc View Administrative OptionView settings *=next #=exit CcccccccccccNnnnnnnnn Pass-thru modeSupplicant mode CccccccccFilename.ext Viewing Parameter ValuesName System Value Format Ccccccc EthernetError and Status Messages Aaa.bbb.ccc.dddExtension Hardware Registration Troubleshooting the 4601 IP Telephone Use by Visual Indication/Cause/Resolution Restart the Telephone Reset values? =no #=yesScenarios for the Restart Process Restarting Boot File Needs to be UpgradedLoading 5 secs Replbootv3.app 4084KB InitializingTftp n Http n uri Starting Updating boot codeDhcp 0 secs * to program Loading 5 secs App 4035 KB Appfilename n KB receivedSaving to flash n%, x secs StartingUpdating ClearingSecs Where n is the number of KBs downloaded Appfilename n KB received 102 4600 Series IP Telephone Installation Guide Index 104 4600 Series IP Telephone Installation Guide Visual Alerting What’s New Index 106 4600 Series IP Telephone Installation Guide