AltiGen comm 600H manual Tftp

Parameter	Description
Display	When enabled, allows the Alti-IP 600 phone to display
Workgrou	workgroup queue status. While the agent is in idle state, the first
p Status	line of the LCD displays the number of queued calls, the current
	longest queue time, and the last four digits of the workgroup
	number; the second line shows the agent state.
H.323	Allows you to set the Jitter Buffer in milliseconds, the delay
	used to buffer voice packets received from the IP network. The
	Jitter Buffer should be adjusted according to the WAN
	bandwidth allocated to data traffic.
	To allow NAT support for the IP extension, check the Enable
	NAT button and enter the public IP address of the NAT router.
Time	• Offset - a per phone-based configuration, allows the phone to
Display	display a different time based on location.
	• Format - a per-phone-based configuration, allows the phone
	to display 24 hour or 12 hour (AM/PM).
TFTP	Allows you to assign the TFTP Server to which the IP phone can
	connect to for updating firmware when necessary. Enter the IP
	address of the TFTP Server in the Server field.
	To update IP phone image, the administrator can check the Reset
	IP Phone and Boot Download check box options to reset and
	download image to update the phone.
Debug	When enabled, allows the Alti-IP 600 phone to connect to Telnet
	for debugging.

Notes:

•IMPORTANT! Please note that the configuration in AltiWare will override the Alti-IP 600H phone’s local configuration after the IP Phone is registered. If the IP phone’s local configuration is changed while in Basic mode, these changes will be overwritten by AltiAdmin/ACM Admin settings. Also, after the IP Phone is successfully registered with the system, the IP phone will overwrite the AltiWare IP address and network-related settings on the server.

Alti-IP 600H Manual 13