AltiGen comm 600H manual Configuring the AltiWare IP Settings

Page 25

•IP subnet mask

•Default gateway IP address

4.Configuring the AltiWare IP Settings

If you are using Gatekeeper Auto Discovery, you do not need to configure anything. Proceed to Step 6.

If you are not using Gatekeeper Auto Discovery, you must manually configure the AltiWare IP address setting into the Alti-IP 600H. Refer to “Configuring IP Settings” on page 26.

5.Activate the IP Extension

Once the device is initialized, the user must follow these steps to activate the IP Extension.

Note: The user must be running AltiGen’s Gatekeeper service for full functionality.

a.With the handset onhook, press # 27, then the ENTER button.

b.Enter your extension number and password when prompted.

c.The phone will attempt to register as shown in the LCD screen.

If the phone successfully passes through these stages, the phone shows the time and extension in the LCD screen and is now in normal operating mode.

Otherwise, refer to “Troubleshooting” on page 40.

Alti-IP 600H Manual 15

Image 25

Contents Administration Manual Trademarks Contents Configuring Phone Settings Glossary Index Alti-IP 600H Manual What The Warranty Covers WarrantyEffect of State Law Overview Preface About This ManualRelated Documentation An Overview of the Alti-IP 600H Alti-IP 600H, Top View Lamp Field key, an AltiServ feature code, a speed New in Version Level Hardware ComponentsHeadset port support Call Record Alti-IP 600H Manual System & Network Requirements AltiAdmin/ACM Admin Configuration RequirementsSystem Requirements Network RequirementsPlug and Play Feature AltiGen IP Phone ServiceBasic Mode Normal OperationManual Setup InstallationIP Phone Configuration Window Parameter Description Demand to Extension VM must be enabled in the Personal Configuration screen on the General page, Record onTftp To connect the Alti-IP 600H Configuring the AltiWare IP Settings Plug and Play Setup Before IP Phone is Started Plug and Play SetupPlug and Play Setup After IP Phone is Started Remote Installation Verifying the Phone Startup Process Resolving Errors Upon StartupRebooting the Alti-IP 600H Restoring Default SettingsConfiguring Phone Setting Soft Keys Headset Port Support Dialing an IP Number Directly from the Alti-IP 600HOperation Notes System Settings Configuring Phone SettingsSetting Menu Path Sub Menu Description Network Settings Enabling Dhcp Modifying Dhcp SettingsDisabling Dhcp Configuring IP SettingsAssigning a Local IP Address Updating Phone Firmware Assigning a Tftp ServerSystemVersion Info Setting Ring Tones Configuring NATAssigning NAT Press * * 6 Enter Workgroup Status DisplayFWD forwarding Activity DisplayAlti-IP 600H Manual Configuration on Feature Description Configuration NotesPhone Functions Go to AltiGen IP PhoneTo AltiGen IP Phone Extension ConfigurationRecord VM in the Personal CallHeadset Call Line button ParkLED for Parked Call Line Then, go to AltiGen IP Phone Configuration Station SpeedAlti-IP 600H Manual Appendix a SpecificationsFirewall Considerations TroubleshootingClient Server Contact AltiGen Technical Support Problem/Symptom SolutionTroubleshooting LCD Messages Local Menu Configuration MessagesAlti-IP 600H/600PH Running Messages Message DefinitionLCD Messages User Reference IP Phone Boot MessagesUser Reference Configuration BLF Feature Codes Call Management Dual Tone Multi Frequency see Dtmf GlossaryAlti-IP 600H Manual Alti-IP 600H Manual Alti-IP 600H Manual Alti-IP 600H Manual Alti-IP 600H Manual Index DSL Alti-IP 600H Manual