AT&T 1040 user manual Line connected to Line

Page 68

Appendix J

In case of difficulty

I cannot transfer outside

• If you are on a conference call with another

calls.

telephone in the same system (page 22), the call

 

cannot be transferred.

 

• If the destination telephone is on an outside call

 

or intercom call with another system telephone,

 

the call cannot be transferred.

 

• All extensions must have the same outside telephone

 

line connected to Line 1.

 

• Make sure the telephone line cord connected

 

to line jack L1/L2 was provided with the tele-

 

phone.

 

• Check to make sure that each telephone set has

 

a unique extension number. If the sets receive

 

AC power at the same time, either at initial

 

installation or after a power failure, the

 

extension numbers may be the same. Refer to

 

the EXTENSION NUMBER section on page 32 of

 

the installation guide.

LOW BATT is displayed on • No spare battery is installed or the spare battery

screen.

needs to be replaced.

 

• Remove and re-install the battery.

The telephone does not ring when there is an incoming call.

Make sure the ringer is on (page 14).

Make sure the telephone line cord(s) and the power adapter are plugged in properly (see the installation guide).

There may be too many extension telephones on the telephone line to allow all of them to ring simultaneously. Try unplugging one phone at a time until the phones start ringing.

Test a working telephone at the same telephone jack. If another telephone has the same problem, the problem is in the telephone jack. Contact your local telephone company (charges may apply).

62

Image 68
Contents User’s manual On purchasing your new AT&T product Canada, dial 1 866Stop Table of contents 1040 Line small business system with speakerphoneIntercom operation Iii Introduction Telephone overview Line ButtonsDo not Disturb TransferVolume EnterHold Headset Conference MuteDisplay screen messages LCD contrastInitializing Indicator lights & tones Indicator lightsOn when the Do Not Disturb function is on. on next LineNEW MSG Alert tonesDirectory card Making and answering calls Lit line indicatorsBasic phone operation Handset SpeakerphoneHeadset purchased separately Handset Ringer volume Volume controlHandset/speakerphone/headset volume Ringer type Ringer on/offL1 RINGER, L2 RINGER, L3 Ringer or L4 Ringer Do not Disturb Last number redial Redial stack To delete a redial numberTo store a redial number in a one-touch key To exit, press Auto RedialPress Speaker Auto-redialPress Speaker or Headset Call waiting Temporary tone dialingHold Switching between lines Cancel call privacyRestore call privacy Call privacyConference calls To talk privately with one party two-line conference onlyTo drop one line To drop an extensionBlind transfer Call transferTransfer a call Answer a transferred call Transfer a call and speak to the receiving partyPress Transfer Conference Intercom overviewALL Intercom Make an intercom call with the handsetMake an intercom call with the speakerphone or headset Answer an intercom call End an intercom or page callPress Intercom VoiceA specific extension single-phone Answer a single-phone Auto-mute off Auto-mute onAll system-wide Press Intercom then to show page ALLPage-all shortcut To end the page allAnswer a system-wide Room monitor One-touch overview One touch PreferenceOne-touch storage ProgramOne-touch storage To dial a one-touch number If one-touch preference is set to IntercomTo delete a one-touch number To view or delete a one-touch numberTo view a one-touch number To modify a one-touch number To modify a one-touch number Forwarding to Dtad mailbox About forwarding to DtadTo turn call forwarding on To set up call forwardingTo set call forwarding delay time Listening to messages internal access Glossary Time/date Set ring delay duration Answer a delayed ringCentrex operation Pick up another station’s lineEXT 12 Console is OFF CSL Delay Ring is set to 20 seconds Console is OFF CSL Delay Ring is set to 16 secondsCentrex service call example EXT XX RingGeneral product care Important product information Especially about corded telephones Especially about telephone answering systemsFCC and Acta information Product identifier and REN informationConnection and use with the nationwide telephone network Repair instructionsHearing aid compatibility Programming/testing of emergency numbersRights of the telephone company Part 15 of FCC rules How long is the limited warranty period? Limited warrantyWhat does this limited warranty cover? How do you get warranty service? 800 222-3111 in Canada, please dial 1 866Other limitations Technical specification Case of difficulty Appears to be dead on Is no dial tone on thisCase of difficulty Line connected to Line Case of difficulty Case of difficulty Case of difficulty Index Index