Note: For values to enter in this field, see the table "Park/Pickup Call Server Configuration Values" on page 24.
6.In the "Line" field, select a line for which to apply the Park con- figuration.
7.Pick a softkey to configure for Picking up a call.
8.In the "Label" field, enter a label for the Pickup softkey.
9.In the "Value" field, enter the approriate value based on the server in your network.
Note: For values to enter in this field, see the table "Park/Pickup Call Server Configuration Values" on page 24.
10.Click | to save your |
changes. |
|
11.Click on Operation->Reset.
12.In the "Restart Phone" field
click 
to restart the IP phone.
Using the Park Call/Pickup Parked Call Feature
Use the following procedure on the IP phones to park a call and pick up a parked call.
Park a Call
1.While on a live call, press the "Park" softkey.
2.Perform the following for your specific server:
For Asterisk Server
-Server announces the extension number where the call has been parked. Once the call is parked, press the ykey to complete parking.
For BroadWorks Server
-After you hear the greeting from the CallPark server, enter the extension where you want to park the call.
For Sylnatro Server
-Enter the extension number where you want to park the call, followed by "#" key.
For ININ Server
-Enter the extension number where you want to park the call, followed by "#" key.
If the call is parked successfully, the response is either a greeting voice confirming that the call was parked, or a hang up occurs. The parked call party will get music on hold.
3.If the call fails, you can pick up the call (using the next proce- dure) and press the "Park" soft- key again to retry step 2.
Pickup a Parked Call
1.Pick up the handset on the phone.
2.Enter the extension number where the call was parked.
3.Press the "Pickup" softkey.
If the call pick up is successful, you are connected with the parked call.
Handling Calls
26480i IP Phone User Guide