Haier HWE08XCN, HWE10XCN Troubleshooting, English, Possible Cause, Remedy, Possible Problem

ENGLISH

TROUBLESHOOTING

POSSIBLE PROBLEM

POSSIBLE CAUSE

REMEDY

Air Conditioner	Power supply cord is not plugged	Plug unit into a mating grounded outlet.
does not start or	into an outlet.
operate
	Power supply cord has tripped.	Press and release RESET button on the power
		supply cord.
	Unit is turned off.	Turn on unit using remote control or on
		control panel.
	A household fuse or circuit breaker	Replace the fuse or reset the circuit breaker.
	has blown.
Remote control is	Batteries are dead.	Replace the batteries.
not working
	Batteries inserted wrong.	Make sure batteries are inserted in the
		correct position.
Room does not	The room is too hot.	Allow time for the room to cool down when
feel cold enough		you turn on the unit.
	The temperature control may not	Adjust the temperature control on the
	be set correctly.	control panel or remote control.
	Air flow is restricted.	Make sure the air discharge area is not
		blocked.
Room feels too	Temperature set too low.	Raise the set temperature.
cold
Air conditioner	Air filter is dirty or restricted.	Clean the air filter.
cycles on and off
	Air flow is restricted.	Make sure the air discharge area is not
too often
		blocked.
	Outside air temperature is below	Do not operate the unit when the outside
	61˚F.	temperature is below 61˚F.
	Outside temperature is very hot.	Raise the FAN speed to the highest setting.
Water drips into	Air conditioner is not properly	Tilt unit slightly from the front to the back.
your house	leveled.	Refer to Installation section. DO NOT drill a
		hole in the cabinet base.
Water drips	Hot, humid weather.	This is normal during days with high humidity.
outside your
house
Water collects in	Humidity drains into cabinet base.	This is normal during days with high humidity.
cabinet base		DO NOT drill a hole in the cabinet base.
Air conditioner is	Temperature outside is too low,	To defrost coil, set to FAN ONLY mode and
freezing up; ice	below 61˚F.	set temperature higher.
forming on coil

PAGE 24 TROUBLESHOOTING