Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| TROUBLESHOOTING & REPAIR | |
| TROUBLESHOOTING GUIDE | Observe Safety Guidelines |
|
| detailed in the beginning of this manual. |
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED |
| |||
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION |
| |||
|
|
|
|
|
|
|
| OUTPUT PROBLEMS |
|
|
|
|
|
No weld output, the auxiliary | 1. Check the open circuit voltage | 1. | Check the continuity (low resis- | |||
power | (OCV) at the welder output ter- |
| tance) from the positive output | |||
mally. Engine runs normally. | minals. Normal is 75 to 82VDC |
| terminal, | through the | choke | |
| with engine at high idle (3750 |
| (L1), to the positive side of the | |||
| RPM) and the output rheostat at |
| output rectifier bridge (D2). See | |||
| maximum. If the correct OCV is |
| Wiring Diagram. |
| ||
| present, go to Step 3, below. | 2. | Check the | continuity | (zero | |
|
| |||||
| 2. If the open circuit voltage is |
| ohms) from the negative output | |||
| NOT present at the welder out- |
| terminal to the negative side of | |||
| put terminals, contact your |
| the output rectifier bridge (D2). | |||
| local Lincoln Electric Authorized |
| See Wiring Diagram. |
| ||
| Field Service Facility. | 3. Perform | the Output Rectifier | |||
|
| |||||
| 3. Check the welding cables, |
| Bridge Test. |
|
| |
| clamps and electrode holder for | 4. | Perform | the | Main | Stator |
| loose or broken connections. | |||||
|
| Winding Test. |
| |||
|
|
|
| |||
|
|
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
WELDANPOWER 125