Return to Section TOC
Return to Master TOC
|
| ||||
|
| MAINTENANCE | |||
|
| TABLE D.2 – ENGINE MAINTENANCE PARTS | |||
|
|
|
|
| |
|
| Part | Part Number |
| |
|
| OIL FILTER | NONE |
| |
|
| SPARK PLUG (STANDARD) | B&S 492167 |
|
|
|
| SPARK PLUG (RESISTOR) | B&S 491055 |
| |
|
|
| CHAMPION RC12YC |
|
|
|
| AIR CLEANER CARTRIDGE | B&S 710266 |
| |
|
|
| (CAN BE CLEANED AND REUSED) |
|
|
|
| AIR | B&S 710268 |
| |
|
| (AS NEEDED) | (CAN BE CLEANED AND REUSED) |
| |
|
|
|
|
|
|
Return to Section TOC
Return to Master TOC
WELDER/GENERATOR MAINTENANCE
STORAGE: Store the WELDANPOWER 125 in clean, dry, protected areas.
CLEANING: Blow out the generator and controls peri- odically with low pressure air. Do this at least once a week in particularly dirty areas.
BRUSH REMOVAL AND REPLACEMENT: See Figure D.6. It’s normal for the brushes and slip rings to wear and darken slightly. Inspect the brushes when a generator overhaul is necessary. Remove the brushes and clean the slip rings with fine grit sand- paper.
To reinstall the brushes, press them upward and slide a cable tie or wooden stick through the brush holder tabs. Install the brush holder into the bearing end bracket and secure with the screws previously removed. Remove the cable tie or wooden stick and the brushes will seat onto the slip rings.
RECEPTACLES: Keep the electrical receptacles in good condition. Remove any dirt, oil, or other debris from their surfaces and holes.
CABLE CONNECTIONS: Check the welding cable connections at the weld output terminals often. Be sure that the connections are always firm.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
CAUTION
Do not attempt to polish slip rings while the engine is running.
FIGURE D.6 – BRUSH REMOVAL AND REPLACEMENT
4 | 2 | 6 |
3 |
| 5 |
|
| |
| 1 |
|
1.GENERATOR END BRACKET
2.BRUSH HOLDER ASSEMBLY
3.COVER
4.SCREWS (2)
5.BRUSHES
6.CABLE TIE
WELDANPOWER 125