Lincoln Electric IM892-C manual Parameter Range Units, Limits may be set for, MSP4 Display

B-34 OPERATION B-34

LIMITS

Limits allow the welder to adjust the welding proce- dure only within a defined range.

Each user memory may have a different set of limits. For example, memory 1 can be set to limit the WFS to 200 through 300 in/min, and memory 2 can be set to limit the WFS to 275 through 310 in/min, while memo- ry 3 may not have any WFS limits.

Parameters are always constrained by machine limits. When memory limits are enabled, the parameter will flash whenever an attempt is made to exceed the memory limit value. The parameter will not flash if an attempt is made to exceed the machine limit.

Machine limits are:

Parameter	Range	Units
Wire Feed Speed	Weld mode dependent	in/min
	and gear box ratio
	dependent
Voltage	Weld mode dependent	Volts
Trim	0.50 to 1.50	--

Limits may be set for:

•Wire Feed Speed/Amperage

•Voltage/Trim

•Arc Control

Weld modes cannot be selected through the Limits Setup memu, and must be chosen and saved to mem- ory before entering the Limits Setup Menu.

Set Limits:

Press 5 seconds

MMEMORYM

PROCEDURE

A GUN B

1 2 3

HOLD 2 SECONDS TO SAVE

4 5 6

To set limits, press the desired memory button 1-6 and hold for 5 seconds. Release the memory button when the LED begins to blink rapidly and the MSP4 displays "Memory X Set Limits" as shown below.

MSP4 DISPLAY

	WAVEFORM CONTROL TECHNOLOGY
	Memory 1
IR PORT
	SETUP
	Set Limits
WELD MODE	START OPTIONS
ARC CONTROL	END OPTIONS
	SET

POWER FEED™ 25M