Tripp Lite APS INT 512 owner manual APS Installation

APS Installation

Configuration DIP Switch Settings*

(See Diagram 1, p. 46. Note: 1.1 is a closeup of the Configuration Dip Switches. 1.2 is “front”, 1.3 is “rear”).

Using a small tool, set the 4 Configuration DIP Switches (located on the bottom of your APS) to select battery type and set the voltage range outside of which your APS will switch to battery power.

* Select before permanently mounting your APS.

• Select Battery Type

(DIP Switch #1)

CAUTION: The Battery Type DIP Switch setting must match the type of batteries you connect or your batteries may be degraded or
damaged over an extended period of time. See “Battery Selection,” page 6 for more information.		Rear
Battery Type	Switch Position	Wet
		Cell

Gel Cell (Sealed) Battery	Front
Wet Cell (Vented) Battery	Rear**

• Select High AC Voltage Point Switch To Battery

Front Rear

Gel

Cell

(DIP Switch #2)		257V
Voltage	Switch Position
276V	Front
257V	Rear**	276V

• Select Low AC Voltage Point Switch To Battery			Front
(DIP Switches #3 & #4)
Rear	Rear	Rear	Rear

Front	Front	Front	Front
200V	181V	162V	144V
#4 Front & #3 Front	#4 Front & #3 Rear	#4 Rear & #3 Front	#4 Rear
			& #3 Rear**
** Factory default settings.

APS INT 512 Conversion from 50 to 60 Hz.

For Qualified Service Personnel Only*

(See Diagram 2, p. 46. Note: 2.1 is the “adjustment resistor” located in the upper right-hand corner of the component side of the circuit board).

To permanently convert the APS INT 512 to 60 Hz., qualified service personnel should open the APS case, locate the resistor on the circuit board and remove it.

* Turn your APS OFF and disconnect from the wall outlet before 60 Hz conversion.

Electrical Connection

Plug APS INT 512 models into outlets providing 230V AC, 50 or 60 Hz. power.

4