DeWalt DeVILBISS manual ON-RECEIPT Inspection, Glossary, Duty Cycle, Accessories

Page 8

ON-RECEIPT INSPECTION

Each air compressor unit is carefully checked before shipment. With improper handling, damage may result in transit and cause problems in air compressor operation.

Immediately upon arrival, check equipment for both concealed and visible damages to avoid expenses being incurred to correct such problems. This should be done regardless of any visible signs of damage to the shipping container.

Report any damages to carrier and arrange for inspection of goods immediately.

For the location or a listing of the nearest Authorized Warranty Service Center, call our toll free number at 1-800-888-2468.

NOTE: Photographs and line drawings used in this manual are for reference only and do not represent a specific model.

GLOSSARY

Become familiar with these terms before operating the unit.

CFM: Cubic feet per minute.

SCFM: Standard cubic feet per minute; a unit of measure of air delivery.

PSIG: Pounds per square inch gauge; a unit of measure of pressure. Code Certification: Products that bear one or more of the following marks: UL, CUL, ETL, CETL, have been evaluated by OSHA certified independent safety laboratories and meet the applicable Underwriters Laboratories Standards for Safety. Cut-In Pressure: While the motor is off, air tank pressure drops as you continue to use your accessory.

When the tank pressure drops to a certain low level the motor will restart automatically. The low pressure at which the motor automatically restarts is called "cut-in" pressure. Cut-Out Pressure: When an air compressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a certain high pressure before the motor automatically shuts off - protecting your air tank from pressure higher than its capacity. The high pressure at which the motor shuts off is called "cut-out" pressure.

Branch Circuit: Circuit carrying electricity from electrical panel to outlet.

DUTY CYCLE

Air compressors should be operated on not more than a 50% duty cycle. This means an air compressor that pumps air more than 50% of one hour is considered misuse, because

the air compressor is undersized for the required air demand. Maximum compressor pumping time per hour is 30 minutes.

ACCESSORIES

Accessories for this unit are available at the store the unit was purchased.

D23766

8- ENG

Page 7 Page 9
Image 8
Page 7 Page 9
Contents
Maintenance Instructions OPERATOR’S ManualImportant Safety Instructions Table of ContentsSafety Guidelines Definitions Hazard Attachments & Accessories What Could HappenHazard Guards or covers which are damaged or Fire, Inhalation, Damage to Vehicle Surfaces Accessories ON-RECEIPT InspectionGlossary Duty CycleAssembly Tools Required for AssemblyTo Install Handle UnpackingTo Assemble Wheels Assemble Rubber Strip if equippedAssemble Rubber Feet if equipped To Add Oil To PumpPlace unit on a level surface Installation Location of the Air CompressorExtension Cords Plug Grounded Outlets Grounding PinAir Distribution System Voltage and Circuit Protection120/240 Dual Voltage Motor Typical Compressed AIR Distribution System Description of Operation OperationKnow Your Air Compressor Pressure Release Valve Check Valve How to StopBefore Starting How to Start Before Each Start-UpCustomer Responsibilities MaintenanceTo Check Safety Valve Air Filter Inspection and Replacement To Drain TankOil CheckingMotor Pulley/Flywheel Alignment Air Compressor Pump Intake and Exhaust ValvesService and Adjustments To Replace or Clean Check ValveOutlet Tube Pressure Relief Tube Nuts Nuts Check Valve Screwdriver Open position nothing is visibleTo Replace Regulator Pressure Switch ReplacementMotor Wing Nut To Replace BeltRegulator Arrow Storage Troubleshooting Pressure reading Problem Cause Correction Problem Cause Correction ENG D23766 Warranty Responsibility of Original Purchaser initial UserManual DEL Operador Armado, funcionamiento, e instrucciones deLesiones serias Causar daños en la propiedad Tabla DE ContenidosDefiniciones DE Normas DE Seguridad Instrucciones Importantes DE Seguridad Cómo prevenirloAdvertencia Riesgo de Explosión Qué puede occurrir Cómo prevenirlo35- SP D23766 Advertencia Riesgo de Quemaduras Qué puede occurrir Advertencia Riesgo de Caída Qué puede occurrirAdvertencia Riesgo de Operación Lasegura Qué puede occurrir Inspección AL Recibir GlosarioCiclo DE Servicio AccesoriosEnsamblado Herramientas necesarias para el ensambleDesempaque Instalación del asaEnsamble de las ruedas Ensamble de las patas de goma Si viene equipadoAplicación de la tira de goma Si viene equipado Para agregar aceite a la bombaDrene el tanque a fin de liberar Instalación Ubicación del compresor de aireCables de extensión eléctrica EnchufeProtección del voltaje y del circuito Sistema de distribución de aireCuando se convierte para Los tubos de plástico o PVC No han sido diseñadosSistema Típico DE Distribución DE Aire Descripción de funcionamiento FuncionamientoConozca su compresor de aire Cómo utilizar su unidad Antes de poner en marchaCómo detenerla Procedimiento para el asentamientoAntes de cada puesta en marcha Cómo poner en marchaCómo verificar la válvula de seguridad MantenimientoResponsabilidades del cliente Cómo drenar el tanque AceiteVerificación CambioPolea y volante del motor Alineación Servicio Y Ajustes Para reemplazar o limpiar la válvula De retenciónTubo de salida Tuercas TuercasVálvula reguladoraPara reemplazar el regulador MotorInterruptor de Presión Reemplazo Tuerca mariposa Cambio de la correaRegulador Flecha Almacenaje Guía DE Diagnóstico DE Problemas Condiciones de flujo mientras se esté Retire y limpie, o reemplace D23766 58- SP Notas Garantía Limitada Responsabilidad DEL Comprador Original Usuario inicialGuide DE Lutilisateur Consignes DE Sécurité Importantes Table DES MatièresMesures DE Sécurité Définitions Conserver ces directives Avertissement Risque dexplosion ou dincendie PréventionAvertissement Risque de projection dobjets Avertissement Risque déclatementRisque Prévention Avertissement Risque de choc électrique Avertissement Risque par inhalationAvertissement Risque de chute Avertissement Risque de brûluresAvertissement Risque relié aux pièces mobiles Risque Avertissement Risque dune utilisation dangereuseCycle DE Service AccessoiresVérification SUR Réception LexiqueInstallation de la poignée AssemblageOutils requis pour lassemblage DéballageAssemblage des roues Assemblage des pieds en caoutchouc si fournisApplication de la bande en caoutchouc si fournie Ajout dhuile à la pompePurgez le réservoir pour Emplacement du compresseur dair RallongesFiche Broche de mise à la terreSystème de distribution dair Moteur deux tensions de 120/240 voltsTension et protection des circuits Système DE Distribution Dair Typique Description du fonctionnement UtilisationFamiliarisez-vous avec votre compresseur dair Utilisation de lappareil Arrêt de lappareil Avant le démarrageSystème de refroidissement non illustré Pompe du compresseur dair non illustréeAvant chaque mise en marche Mise en marcheVérification de la soupape de sûreté EntretienResponsabilités du consommateur Filtre à air Inspection et remplacement Vidange du réservoirHuile VérificationAlignement de la poulie et du volant- moteur Remplacement ou nettoyage de la soupape de retenue Réparations ET RéglagesMoteur Manostat RemplacementRemplacement du régulateur Écrou à oreilles Remplacement de la courroieRégulateur Flèche Rangement Placez le levier « On/Auto/Off » à la position « Off »Dépannage De modifier le réservoir dairDe quelque façon. Celui-ci Risquerait de rompre ouSi la soupape fuit toujours Le moteur ne Bruit de cliquetis 89- FR D23766 90- FR 91- FR D23766 Garantie Limitée Responsabilité DE Lacheteur Dorigine utilisateur initial
Top Page Image Contents