9.MOUNTING INSTRUCTIONS
Mounting the charger to the fender well: The charger can be mounted directly to the fender well of your vehicle, as shown. If using the nuts and bolts provided, drill two holes between 3/16" and 1/4" in diameter. (For alignment
of holes use the charger as a template.) If
the backside of the mounting surface is hard to reach, you may consider using two 1/2" long sheet metal screws (not included) instead of the nuts and bolts provided.
Mounting the charger alongside the battery:
The charger can also be mounted alongside your vehicle’s battery using
the bracket provided. If possible, mount the charger to the side of the battery away from the engine and fan blades. Mount the bracket to the
charger as shown using the nuts and bolts provided. Loosen the battery retaining hardware enough that you can insert the bracket between the bottom of the battery and the battery mounting tray as shown. Position the charger so that it will not rub against the battery or any other part of the vehicle, and then tighten the battery retaining hardware. NOTE: Do not drill or puncture the battery.
Electrical Installation – The output leads of the charger are terminated with 3/8" dia. ring lugs. Route and secure the AC cord and the output wiring away from the gas line, carburetor or other hot, sharp, moving or pinch parts to avoid damage to the insulation. Secure the AC cord using a cable tie or equivalent. If you have difficulty connecting the output leads, consult your local auto supply store, they may assist you in finding a connecting device for your application.
10.ASSEMBLY INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the battery charger.
• 9 •