Napa Essentials 85-300A manual Control Panel, LED Indicators, Operating Instructions, Charging

Page 10

11.CONTROL PANEL

LED Indicators

(POWER ON) green LED: The charger is connected to an AC power source and is receiving power.

(CHARGED) red LED: The battery is fully charged and the charger is in maintain mode.

12.OPERATING INSTRUCTIONS

This battery charger must be properly assembled in accordance with the assembly instructions before it is used.

Do not start the vehicle with the charger connected to the 120V AC outlet, or it could result in damage to the charger. The charger does not have an ON/OFF switch. The On and Off commands are controlled by plugging the charger into a 120V AC electrical wall outlet only after the battery connections have been made.

Charging

1.Ensure that all of the charger components are in place and in good working condition.

2.Connect the battery following the precautions listed in sections 6 and 7.

3.Connect the AC power, following the precautions listed in section 8.

4.The (green) LED will light when the AC cord is properly connected. When the battery is charged, the (red) LED will light.

5.To disconnect, reverse the procedure.

NOTE: This charger is equipped with an auto-start feature. Current will not be supplied to the ring terminals until a battery is properly connected. The clips will not spark if touched together.

Automatic Charging Mode

When an Automatic Charge is performed, the charger switches to the Maintain Mode (see below) automatically after the battery is charged. For a battery with a starting voltage under 1 volt, use a manual charger to pre-charge the battery for five minutes to get additional voltage into the battery.

• 10 •

Image 10

Contents Voltage / Tensión / Tension Amperage / Amperaje / Ampérage Important Safety Instructions Save These Instructions Risk of Electric Shock or FireRisk of Explosive Gases Personal Precautions Risk of Explosive Gases Charger Location Risk of Explosion Contact with Battery Acid DC Connection Precautions Page Page Assembly Instructions Mounting the charger alongside the batteryMounting Instructions Control Panel LED IndicatorsAutomatic Charging Mode Operating InstructionsMaintenance Instructions Maintain Mode Float Mode MonitoringCompletion of Charge Troubleshooting Problem Possible Cause REASON/SOLUTION Moving and Storage InstructionsProblem Possible Cause REASON/SOLUTION Power on Before Returning for Repairs Page EL Riesgo DE Descarga Eléctrica Incendio Riesgo DE Gases Explosivos Precauciones Personales Riesgo DE Gases Explosivos Page Precauciones DE Conexión EN CC Page Page Page Para montar el cargador al interior del guardafango Instrucciones DE MontajePara montar el cargador al lado de la batería Instrucciones DE Operación Panel DE ControlIndicadores LEDs CargaFinalización de la carga Modo de carga automáticaModo de mantenimiento Monitoreo a modo de flote Instrucciones DE Mantenimiento Localización Y Solución DE Problemas Posible CausaInstrucciones Para EL Manejo Y Almacenamiento Problema Posible Causa Solución Problema Posible Causa Solución Antes DE Devolver a Reparaciones Page Page Risque DE Choc Électrique OU ’INCENDIE Risque DE GAZ Explosifs Précautions Personnelles Risque DE GAZ Explosifs Page Précautions SUR LA Connexion C.C Page Page Directives DE Montage Montage du chargeur sur l’aile avantPanneau DE Contrôle VoyantsConsignes D’UTILISATION Mode de chargement automatiqueLe chargement Chargement complet Mode Entretien Contrôlant le Mode de monitorConsignes D’ENTRETIEN Tableau DE Dépannage Problème Cause Possible RAISON/SOLUTION Instructions DE Transport ET StockageProblème Cause Possible RAISON/SOLUTION Problème Cause Possible RAISON/SOLUTION Problème Cause Possible RAISON/SOLUTION Avant DE L’ENVOYER Pour Réparation