For Machines Mfg. Since 8/09 | P R E P A R A T I O N | Model SB1040/SB1041 |
Improper connection of the
Check with a qualified electrician or service personnel if you do not understand these grounding requirements, or if you are in doubt about whether the tool is properly grounded.
If you ever notice that a cord or plug is damaged or worn, disconnect it from power, and immediately replace it with a new one.
Extension Cords
We do not recommend using an extension cord with this machine. If you must use one, only use it if absolutely necessary and only on a temporary basis.
Extension cords cause voltage drop, which may damage electrical components and shorten motor life. Voltage drop increases as the extension cord size gets longer and the gauge size gets smaller (higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine must contain a ground wire, match the required plug and receptacle listed in the Circuit Requirements for the applicable voltage, and meet the following requirements:
Minimum Gauge Size............................12 AWG
Maximum Length (Shorter is Better) ....50 ft.
Unpacking
This item was carefully packaged to prevent damage during transport. If you discover any damage, please immediately call Customer Service at (360)
Inventory |
| |
Main Inventory: (Figure 4) | Qty | |
A. | Machine | 1 |
Optional Inventory: (Figure 5) | Qty | |
B. | Circle Cutting Jig | 1 |
C. | Cap Screws | 2 |
D. | Lock Washers 8mm | 2 |
The circle cutting jig and its mounting hardware are not required for operation. Their installation and use is covered in Circle Cutting Jig on Page 36.
A
Figure 4. Main inventory.
B |
C |
D |