6.Place eyebolt/nut assemblies onto hinge of safety shield (D).
See Figure 3.
H
N 
T
U 
U
T
Figure 3
7.Insert safety shield assembly through 2 washers (U) and holes in table top.
8.Before securing safety shield assembly in place, pivot the safety shield and make sure the safety shield rear does not come in contact with table top. Use previously installed nuts to raise/lower safety shield assembly as necessary.
9.Secure safety shield assembly in place with 2 washers (U) and 2 hex nuts (T). See Figure 3.
10.Use a #2 Phillips screwdriver to attach switch box (E) to switch box bracket (C) with 3 pan head screws (V). See Figure 4.
E
| PU | LL | ON | |
|
| FF | ||
| PUS | H O |
| |
| RESE | T |
| |
|
|
| ||
OUTLET | S |
|
| V |
|
|
| ||
Figure 4
Assemble Fence and Miter Guide
W (4)
X (4) | U (4) |
Y (4)
1. Attach left fence (F) to left fence base (H) using 2 flat countersink bolts, (W), 2 washers (X), and 2 wing nuts (Y).
Repeat for right fence (G) and right fence base (J). See Figure 5.
F
Y 
X 
H
W
Figure 5
10