Wolfcraft 6157 manual Circuit Breaker, Table Flatness Adjustment

Circuit Breaker

If an overload occurs, the circuit breaker inside the switch box trips and interrupts power to the router and any accessories. If this happens:

1.Unplug the power cord.

2.Remove the workpiece from the router bit and table.

3.Find the cause of the overload and correct.

4.Push the reset button to reset it. See Figure 17.

5.Plug in power cord.

6.Follow instructions under Operation of Switch Box and Router to reset router.

OU

TLETS

PULLON

PUSHOF

RESETF

reset button

Figure 17

Table Flatness Adjustment

Your router table comes equipped with an L-bracket mounted under it to help ensure the flatness of the working surface. If the router table should ever become warped, the flatness can be adjusted by shimming under the L- bracket. Loosen L-bracket mounting screws and place shims as necessary. Tighten L-bracket screws securely. Check table top flatness with a straightedge or the edge of a carpenter's square. See Figure 18.

When router table is

WARNING not in use, always:

1.Place the switch box in OFF position and remove the safety key.

2.Place router power switch in OFF position.

3.Unplug switch box from wall outlet.

4.Remove router bit.

5.Make sure router collet assembly is below router table.

6.Remove and place safety key in a secure location. Remember where you place the safety key.

If breaker trips, or the WARNING router stalls, or if the power

fails for any other reason, place the switch box in the OFF position, remove the safety key, and unplug the switch box from the wall outlet.

L-bracket

shim

mounting screws

Figure 18

17