Wolfcraft 6157 manual Ets

3.Use the screws removed from the router base plate to attach the adaptor base plate to the router base. Tighten screws securely.

4.Mount the router with adaptor base plate using the through holes in tabletop and router base and then into the mounting nuts. Tighten securely. (The adaptor base plate comes from the factory with mounting nuts pressed into it.)

See Figure 10.

CAUTION Make sure the screws from router base plate are

long enough to mount router securely. Replace if necessary.

5.Mount the router with adaptor base plate putting the machine screws (AA) through the holes in the tabletop and router base. TIghten securely. See Figure 10.

AA

	ULL	ON
P		H OFF
PUS		ET
RES

OUTL ETS

G

N

I

N

R

A

W

Figure 10

II.Mounting Routers with Three- Hole Base Plate (Hole Pattern "E")

AA (3)

1.Remove router base plate from router by removing screws.

2.Loosen knobs and slide fences so that notches in fences line up to clear mounting holes.

3.While holding router upside down, position it to the underside within the center ring of the table top.

4.Rotate router until the three mounting holes in router base line up with the three larger holes in the table top.

NOTE: For ease of use, position the router so the ON-OFF switch is accessible from the front of the table.

5.Insert three machine screws (AA) through holes in tabletop and into router mounting holes. Tighten securely. See Figure 11.

AA

G

N

I

N

R

A

W

Figure 11

Make sure the screws CAUTION from router base plate are

long enough to mount router securely. Replace if necessary.

13