Bosch Power Tools 4410L manual Checking Left Bevel Stop, Calibrating Left Bevel Stop

Checking Left 45°

Bevel Stop

1.Lower head assembly and engage head assembly lock pin.

2.Slide head assembly completely to the back and tighten the rail lock knob.

3.Rotate table to the 0° miter position.

4.Pull up bevel lock lever to unlock bevel.

5.Move bevel range selector knob to 45°-0° position. (See page 28)

6.Tilt the saw assembly to the left, then rotate saw assembly to the right until you feel the stop in the 45° left position. This is where the saw is current- ly set for the 45° left bevel cut.

7.Use the head (remove ruler) of a combination square to check blade at the 45° stop. Place the combination square head on the table and press it’s 45° surface against the blade. If the blade does not contact the full length of the square, (figure 1), follow the calibrating procedure.

Calibrating Left 45°

Bevel Stop

1.Remove rear cover to expose bolts.

2.Lift bevel lock lever to release bevel lock.

3.Tilt saw to 45° left bevel position.

4.Remove the ruler from the combination square and position with 45° surface against blade. (Figure 1)

5.Place 10mm open-end wrench on bolt head “F”. While rotating bolt “F”, watch blade tilt movement until it is aligned with the 45° surface on combina- tion square. (Figure 2)

6.Adjust bevel pointer to 45° line on bevel scale.

Adjusting Bevel Lock

Lever Tension

1.Lift bevel lock lever to release bevel lock.

2.Place 17mm open-end flat wrench on bolt head “E” (Figure 2).

3.Turn nut “E” clockwise 1/8 turn to tighten bevel lock tension or turn counter-clockwise to 1/8 turn to loosen bevel lock tension.

Blade

Table	Bevel Lock
Combination Square	Lever

Figure 1. Left 45° Bevel Stop

E

F

Figure 2. Left 45° Bevel Adjustment

4.Push down bevel lock lever until you feel the lever snap into the locked position.

5.Verify that bevel lock tension holds the bevel posi- tion secure and also allows bevel lock lever to lock down to the point that a solid stop is felt.

6.If necessary, repeat steps 1–5 to adjust the tension.

15.