Bosch Power Tools 4410L manual Compound Cuts, Follow these instructions for making, Your bevel cut

slightly to the left while rotating the bevel range	2.	Properly position workpiece. Make sure work piece
selector knob with left hand to “Max Range”		is clamped firmly against the table and the fence.
(Figure 2).		NOTE: Use clamping position that does not inter-
d. Tilted saw head to any angle from 47° left to 46°		fere with operation.
right.	3.	Before turning the saw on, practice the cutting
e. Push down bevel lock lever until you feel the lever		action to make sure the fence clears the guards
snap into the locked position.		and adjust as necessary.
	4.	Follow the procedures for either a chop cut or slide
Follow these instructions for making		cut (see page 26).
your bevel cut:	5.	Wait until blade comes to a complete stop before

1. Extend the base extensions on the side on which	returning head assembly to the raised position
the cut will be made. (See Sliding Fence and Base
	and/or removing workpiece.
Extension on page 25).

Compound Cuts

•A “compound cut” is a cut made with the blade set to both an angle relative to the fence (miter angle) and an angle relative to the base (bevel angle).

•A compound cut can be made as either a chop cut or a slide cut depending on the width of the work- piece.

•Because it may take several tries to obtain the desired compound angle, perform test cuts on scrap material before making your cut.

Follow these instructions for making your compound cut:

1.Extend the base extensions and fences on the side on which the cut will be made. (See Sliding Fences and Base Extensions on page 25.)

2.Properly position workpiece. Make sure workpiece is clamped firmly against the table or the fence.

Use clamping position that does not ! WARNING interfere with operation. Before

switching on, lower head assembly to make sure clamp clears guard and head assembly.

3. Set miter and bevel angles according to the instructions on page 28 for miter and bevel cuts.

4. Follow the procedures for either chop cut or slide cut (see page 26).

5. Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

Quick-Action

Clamp

Workpiece

Sliding	Bevel Angle	Miter
Base	Scale	Angle

Figure: Compound Cut

29.