Bosch Power Tools 4410L manual Crown Molding Laying Flat on Table

Saw Operations (continued)

Crown Molding Laying Flat on Table

Notes: Position workpiece with its back flat on the saw table.

Always place top edge of molding against fence (Decorative edge is at the bottom of crown molding.)

•"Spring angle" refers to angle between wall and crown molding.

•Cutting crown molding flat on the table can be done either as a chop cut or a slide cut depending on the width of the workpiece.

1.For 90° corner, set the bevel and miter angles using Charts below. Tighten the miter lock knob and the bevel lock lever.

2.Position molding on saw table. Clamp workpiece in place using the quick clamp.

!WARNING Use clamping position that does not interfere with operation. Before

switching on, lower head assembly to make sure clamp clears guard and head assembly.

3.Follow procedures for either chop cut or slide cut (see page 26).

4.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

NOTE: ALWAYS TAKE A TEST CUT USING SCRAP TO CONFIRM CORRECT ANGLES.

Quick-Action

Clamp

Crown

Molding

33.9° Bevel 31.6° Miter

Figure: Crown Molding Laying Flat

Miter and Bevel Settings for Standard Crown Molding Cuts

(When Crown Molding is Lying Flat on Table)

Assumptions: Molding is milled consistently. Corner is exactly 90°.

Molding Spring Angle is 38 degrees

	Miter	Bevel
	(Table)	(Tilt)
	Setting	Setting
Inside Corner
Left end (A)	(31.6) Right	(33.9) Left
Use the left end of the cut
Right end (B)	(31.6) Left	(33.9) Right
Use the right end of the cut
Outside Corner
Left end (C)	(31.6) Left	(33.9) Right
Use the left end of the cut
Right end (D)	(31.6) Right	(33.9) Left
Use the right end of the cut

Molding Spring Angle is 45 degrees

	Miter	Bevel
	(Table)	(Tilt)
	Setting	Setting
Inside Corner
Left end (A)	(35.3) Right	(30.0) Left
Use the left end of the cut
Right end (B)	(35.3) Left	(30.0) Right
Use the right end of the cut
Outside Corner
Left end (C)	(35.3) Left	(30.0) Right
Use the left end of the cut
Right end (D)	(35.3) Right	(30.0) Left
Use the right end of the cut

32.