Assembly (continued)
Attaching Miter Lock Knob
Locate the miter gauge lock knob from among the loose parts, and thread shaft into miter detent assem- bly as shown in illustration.
Miter Gauge | Shaft |
Lock Knob |
|
Figure: Miter Lock Knob
Assembling Dust Elbow
And Dust Bag
1.With the miter arm locked in the down position, push the dust elbow onto the dust port. Push the dust bag onto the elbow and rotate both to desired position.
2.Position dust chute/bag so that it does not interfere with the tool during the cutting operation for all miter/bevel settings. Make sure dust bag does not interfere with the slide rails during slide cutting.
3.The dust bag requires emptying when full of sawdust. Empty it frequently and after completion
of sawing. Carefully remove dust bag from dust elbow. Empty dust bag in proper trash bin by unzipping the bag. Be extremely careful of dust disposed, materials in fine particle form may be explosive. Do not throw sawdust on an open fire. Spontaneous combustion, may in time, result from mixture of oil or water with dust particles.
NOTE: The dust port accepts the Bosch VAC004 Vacuum Hose Adapter, which allows connection to a Bosch 35mm vacuum hose.
When sawing chemically pressure treated lumber, paint that may be lead based, or any other materials that may contain
carcinogens, use special precautions. A suitable res- pirator must be worn by all personnel entering the work area. Work area should be sealed by plastic sheeting and persons not protected should be kept out until work area is thoroughly cleaned.
Dust Elbow
Dust Bag
Dust
Port
Figure: Dust Elbow and Dust Bag
12.