Bosch Power Tools 4410L Blade Square to Fence, Miter Scale Indicator Adjustment, Fence Alignment

Adjustments (continued)

!WARNING Disconnect plug from power source before performing any assembly,

adjustment or repair to avoid possible injury.

Blade Square to Fence

1.Slide saw forward so blade is near the center of the table and tighten slide rail lock knob.

2.Lower head assembly and engage head assem- bly lock pin.

3.Set table at the 0° miter position and tighten miter lock knob.

4.Place combination square against fence with ruler of square parallel to blade. Ruler should contact blade, but not blade teeth. If blade is not square against ruler, follow the fence alignment proce- dure. (Figure 1)

5.Loosen rail lock knob and slide head assembly back to check squareness of complete slide cut against the square’s ruler.

Fence Alignment

a.Remove both fences by loosen fence knob, slide fence to full in position, and pull up on fence.

b.The head assembly should remain in lowered position.

c.Loosen the four (4) hex bolts behind fence using multi purpose wrench (Figure 2).

d.Adjust fence until blade and fence have full con- tact with the square.

e.Tighten the four (4) hex bolts.

f.Re-attach sliding fence.

Fence

Blade

Combination Square

Figure 1. Blade Square to Fence

Hex Fence

Fence HexBolts Knob

Knob Bolts

Figure 2. Fence Adjustment

Miter Scale

Indicator Adjustment

1.Set table at the 0° miter position and tighten miter lock knob.

2.Raise the head assembly to the full-up position.

3.Loosen the Phillips screw that holds the indicator in place.

4.Position the indicator to align with the 0° miter mark and tighten the screw.

Indicator

Adjustment

Screw

							0	85
						85
					80				5
55			70	75
	60	65						0
							5
			.5			10
	31
			22
	.6			20	15
35		30 25

0° Mark

Miter Scale

Indicator

3	6
35	55
40	50
	45

Figure: Miter Scale Adjustment

16.