Bosch Power Tools 4410L manual Checking Right Bevel Stop, Calibrating Right Bevel Stop

! WARNING

Adjustments (continued)

Disconnect plug from power source before performing any assembly,

adjustment or repair to avoid possible injury.

Checking Right 45°

Bevel Stop

1.Lower head assembly and engage head assembly lock pin.

2.Slide head assembly completely to the back and tighten the rail lock knob.

3.Rotate table to the 0° miter position.

4.Pull up bevel lock lever to unlock bevel.

5.Move bevel range selector knob to “0°-45° Right” position. (See page 28)

6.Tilt the saw to the right until you feel the stop in the 45° right position. This is where the saw is cur- rently set for the 45° right bevel cut.

7.Use a combination square to check blade at the 45° stop. Place the combination square head on the table and press it’s 45° surface against the blade. If the blade does not contact the full length of the square, (figure 1), follow the calibrating pro- cedure.

Calibrating Right 45°

Bevel Stop

1.Lift bevel lock lever to release bevel lock.

2.Tilt saw to 45° right bevel position.

3.Position combination square with 45° surface against blade. (Figure 1)

4.Insert 3 mm “L” wrench into hole in vertical support frame. (Figure 2)

5.Rotate “L” wrench while viewing blade against combination square until it matches 45° surface.

6.Adjust bevel pointer to 45° line on bevel scale.

Combination

Square

Figure 1. Right 45° Bevel Stop

3mm

“L”

Wrench

Adjusting Access Hole

Bevel

Pointer

Figure 2. Right 45° Bevel Adjustment

14.